Woodstock W1823 manual Setup

Model W1823 (Mfg. Since 9/10)
6. Using the square port in the blower housing (see
Figure 12) for access, fasten the magnetic switch
bracket on the studs with (2) 5⁄16" flat washers and
(2) 5⁄16"-18 hex nuts.
7. With the help of another person, lift and position the		Magnetic
dust collector upright, then lock the casters so the		Switch
unit will not move during the rest of the assembly	Mounting	Bracket
process.	Bolts
	Figure 12. Magnetic switch installation.

8.Have another person hold the cyclone funnel in- place against the intake barrel, and align the datum point labels, as shown in Figure 13, then clamp the cyclone funnel and the intake barrel together using the barrel clamp. To ensure a tight seal, make sure the clamp is tight when it overlaps, as shown in

Figure 13.

9.Connect the outlet port and its larger gasket to the filter canister with (6) 5⁄16"-18 x 3⁄4" button head cap screws. Do not overtighten the screws, or the outlet port flanges will bend and cause the gaskets to leak.

10.Have another person hold the canister filter in place while you fasten the outlet port and its smaller gasket to the blower housing with (8) 5⁄16"-18 x 1⁄2" button head cap screws, as shown in Figure 14.

11.Reach inside the canister filter and rotate the cleaning flap so the flat on the filter cleaning rod faces outward.

12.Place the cleaning handle onto the shaft, align the flat and set screw, then tighten the set screw (see

Figure 14).

-15-

Overlap
Intake Barrel	SETUP
Alignment
Cyclone
Funnel

Figure 13. Cyclone funnel installation.

Outlet Port

Set

Screw

Figure 14. Filter canister installation.