Woodstock W1823 manual Collection lid installation

Model W1823 (Mfg. Since 9/10)

16. With the cyclone funnel port still open for access to the hex nuts inside, fasten the ends of the lift cables to the outside of the cyclone funnel, as shown in Figure 18, using the pre-installed hex bolts.

17.	Slide the 7" hose clamps onto the ports of the		Lift Cable
			End
	collection drum lid and the cyclone funnel (see
	Figure 18).
	Tip: You can disassemble the hose clamps for more
	clearance to get the clamps positioned over the
	hose. To reassemble the clamps, refer to Figure 19.
18.	Work the 7" hose onto both ports, position the hose	Figure 18. Collection lid installation.

clamps on the hose, then tighten them.

19.Connect the ground wire between the drum cover and leg with the included (2) 5⁄16"-18 x 1⁄2" flange screws, as shown in Figure 20. This wire prevents accumulation of static electricity at the collection drum.

20.Position the lift cable in the wheel grooves.

Figure 19. Correct hose clamp assembly.

Flange

Screws

Ground Wire

Ground Screw

SETUP

21.Lower the lid release lever and verify that the lower edge of the lid flange is approximately 25⁜1⁄2" above the floor, as shown Figure 21 so the dust collection drum can be rolled under the dust collector without interference from the lid.

—If the drum hits the lid when it is raised, loosen the hose and reposition the lid higher. Do not attempt to adjust the cables.

Figure 20. Ground wire location.

Release

Lever

Figure 21. Checking collection lid lift.

-17-