Yeoman YM-CL5W, YM-CL8W, YM-CL8MF manual Removal of the LOG Guard, Fitting and Removal of Firebricks

MAINTENANCE and SERVICING

1.5During this time the appliance may give off some unpleasant odours. Keep the room well ventilated to avoid a build-up of fumes.

1.6Your Yeoman retailer can carry out service and maintenance.

2.REMOVAL OF THE LOG GUARD

2.1To remove the Log guard:

—Lift Log Guard clear of the supporting brackets.

—Rotate to clear the sides of the door opening.

Do not use appliance without the log guard in position.

3.FITTING AND REMOVAL OF FIREBRICKS

3.1See Installation Instructions, Section 3.

4.FITTING AND REMOVAL OF BAFFLE

4.1See Installation Instructions, Section 4.

4.2It is important to remove and clean the Baffle system to ensure the flue ways are clear of soot and debris and to ensure the safe and efficient operation of the stove. The frequency of cleaning depends on the stove operating conditions.

4.3The baffle system is designed to give safe and efficient operation of the stove. Replace any damaged baffle immediately.

4.4Do not modify the baffle system.

5.FITTING A NEW DOOR GLASS

5.1To maintain safe use of the appliance damaged door glass must be replaced immediately. To do this:

—Open door and lift free of hinge blocks.

—Lay door face down on a soft flat surface to protect the paintwork and glass.

—Remove the glass clamp and screws x 8. The old glass can then be lifted clear of the door. Note how the sealing rope is placed around the glass.

Dispose of the old glass safely.

Fixing Screws x 8

Glass rope

seal

B

Glass rope				Door
seal
A				PR8738
		Length (mm)
Seal	Yeoman	Yeoman	Yeoman
	CL3	CL5		CL8
Glass rope seal A	930	1025	1220
Glass rope seal B	255	340	460

Black face

Glass rope

seal

B

PR8739

Glass rope seal

A PR8757

26