6.) Clamp locking pliers onto track and rewind springs.
IMPORTANT: If door still does not operate properly, then contact a trained door system technician.
| Spring | |
Approved |
| |
winding rods | Winding cone | |
Spring | Torsion | |
shaft | ||
| ||
| Typical center | |
Set screws | bearing bracket | |
| ||
| Winding cone | |
| Approved | |
| winding rods | |
Winding cone |
|
24 | Label Placement |
Tools: Step Ladder |
IMPORTANT: Using the illustration, attach the appropriate labels to the ap- propriate location on the section, as shown.
NOTE: The Spring Warning tag(s) are factory attached (one per spring).
NOTE: Because of different configurations, some labels may require minor relocations.
Torsion spring tag(s) (one per spring)
WARNING
Residential Dust label
(For California Residents Only)
Residential
warning label
WARNING
HIGH SPRING TENSION CAN CAUSE
SERIOUS INJURY OR DEATH.
DO NOT adjust, repair or remove springs or parts to which springs are connected, such as steel brackets, cables, wood blocks, fasteners or other parts of the counterbalance system.
Adjustments or repairs must ONLY be made by a trained door systems technician using proper tools and instructions.
DO NOT remove, cover or paint over this tag. Product user should inspect this tag periodically for legibility and should order a replacement tag from the door manufacturer, as needed.
WARNING
Lift handles/gripping points are required on this door, located as spelled out in the installation instructions, even if the door is motor operated.
Failure to install and use these lift handles/ |
|
|
gripping points on this door can result in |
|
|
serious injury to fingers and/or hands, if |
|
|
placed in the opening between sections, |
| IMPORTANT |
when the door is operated manually. |
| |
WARNING |
| THIS WOOD PRODUCT REQUIRES PROPER |
| ACC0RDANCE TO THE DIRECTIONS GIVEN IN THE | |
|
| FINISHING PRIOR TO ANY DOOR HARDWARE BEING |
|
| APPLIED. BOTH INNER AND OUTER FACES OF THE |
|
| SECTION(S), AS WELL AS ALL EDGE SURFACES |
| important notice | MUST BE PREPARED AND FINISHED IN STRICT |
The adjacent bottom corner bracket and | Wood label | MANUAL UNDER “MAINTENANCE AND PAINTING |
| INSTALLATION INSTRUCTIONS AND OWNER’S | |
all cable retention features including |
| INSTRUCTIONS FOR ALL WOOD DOORS”. |
milford pins, cotter pins, & clevis pins are |
| IMPROPER STORAGE, IMPROPER TRANSPORTATION |
under HIGH SPRING TENSION. |
| THE EXPOSURE OF THIS WOOD PRODUCT TO |
Adjustments and repairs must only be |
| THE LIMITED WARRANTY. |
|
| MOISTURE AND/OR OTHER CONTAMINANTS, VOIDS |
made by a trained door systems |
|
|
technician, using proper tools and |
|
|
instructions. |
|
|
DO NOT REMOVE, COVER OR PAINT OVER |
|
|
THIS LABEL. PRODUCT USER SHOULD |
|
|
INSPECT THIS LABEL PERIODICALLY FOR |
|
|
LEGIBILITY AND SHOULD ORDER A |
|
|
REPLACEMENT FROM THE DOOR | Bottom section warning labels | |
MANUFACTURER AS NEEDED. | ||
Lift handles/gripping points are required on this door, located as spelled out in the installation instructions, even if the door is motor operated.
Failure to install and use these lift handles/ gripping points on this door can result in serious injury to fingers and/or hands, if placed in the opening between sections, when the door is operated manually.
WARNING
The adjacent bottom corner bracket and all cable retention features including milford pins, cotter pins, & clevis pins are under HIGH SPRING TENSION.
Adjustments and repairs must only be made by a trained door systems technician, using proper tools and instructions.
DO NOT REMOVE, COVER OR PAINT OVER THIS LABEL. PRODUCT USER SHOULD INSPECT THIS LABEL PERIODICALLY FOR LEGIBILITY AND SHOULD ORDER A REPLACEMENT FROM THE DOOR MANUFACTURER AS NEEDED.
16
Please Do Not Return This Product To The Store. Contact your local
refer to your local yellow pages business listings or go to the Find a Dealer section online at