Wayne-Dalton installation instructions Models 105/110, 310/311, B l e O f C o n t e n t s

Page 1

Models: 105/110, 310/311

T o r s i o n

Rear Mount Low Headroom

MH

installation instructions and owners manual

GARAGE DOORS & OPENERS

T a b l e O f C o n t e n t s

Parts Breakdown

2

Pre-Installation

3

Important Safety Instructions

3

Tools Required

3

Package Contents

3

Door Section Identification

4

Graduated End Hinge And Strut Identification

4

Removing an Existing Door

5

Preparing the Opening

5

Installation

7

Optional Installation

17

Door Arm Hookup

17

Lift Handles

17

Pull Down Rope

17

Maintenance

18

Cleaning Your Garage Door

18

Painting Your Garage Door

18

Clear Or Stained Finishes

18

Operation and Maintenance

18

Warranty

20

Dealer Locator Information

22

IMPORTANT NOTICES!

Wayne-Dalton highly recommends that you read and fully under- stand the Installation Instructions and Owner’s Manual before you attempt this installation.

To avoid possible injury, read the enclosed instructions carefully before installing and operating the garage door. Pay close attention to all warnings and notes. After installation is complete, fasten this manual near garage door for easy reference.

The complete Installation Instructions and Owner’s Manual are available at no charge from:

Wayne-Dalton, a Division Of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH., 44660,

Or Online At www.Wayne-Dalton.com

©Copyright 2012 Wayne-Dalton, a Division Of Overhead Door Corporation

Part No. 347785

REV1 03/08/2012

Image 1
Contents B l e O f C o n t e n t s Models 105/110, 310/311F2. F3 G11 H1. G10 Track Rollers As RequiredG12 Package Contents Important Safety Instructions Tools RequiredBottom Section can be identified by #1 Door Section IdentificationIntermediate I Section can be identified by #2 Preparing the Opening Removing an Existing DoorBackroom Requirements Headroom Requirements Page Track Roller Carriers Graduated End And Center HingesStrutting Top Fixtures Half Center HingesBottom Section Follow the corresponding steps belowStacking Sections Vertical TracksTop Section Cable Lift Sheaves Horizontal TracksRear Back Hangs Torsion Spring Assembly If you have two Torsion Keyed Shafts If you have a Torsion Shaft or a Torsion Keyed ShaftRepeat the same process for the other side For Doors with a Coupler Assembly For Doors without Coupler AssemblyTorsion Spring Attachment Tools Locking pliers, 3/8 WrenchTools Vice Clamps Winding SpringsApproved Winding rods Tools Step LadderTypical center Torsion spring tags one per springDoor Arm Hookup Tools Power drill, 1/8 Drill bit, Tape measureLift Handles Pull Down RopeOperation and Maintenance Cleaning Your Garage DoorPainting Your Garage Door Clear Or Stained FinishesPage Limited warranty Wayne Wood, Raised Panel, 105/110, 310/311 Warranty