Wayne-Dalton 9800 installation instructions Nylon Center Bushing

Tools Needed:

NOTE: The set screws used on all torsion counterbalance winding cones and cable drums, are now colored red. DO NOT identify right and left hand by the set screw color.

Slide the nylon center bushing onto the torsion tube followed by the springs and cable drums. The nylon center bushing, springs and cable drums must be positioned, as shown. With assistance, pick up the torsion assembly and slide one end of the tube through one end bearing bracket. Lay the torsion tube into the center bearing bracket and slide the other end of the tube into the opposite end bearing bracket. Position the torsion tube so that equal amounts of the tube extend out from each end bearing bracket.

Equal

SPACING

Center bracket

End bearing bracket

INSTALLATION

15		Center bearing bracket
	Nylon Center Bushing		Torsion
			Spring
Tools Needed:	Slide the nylon center bushing into the	Torsion
Step Ladder	stationary spring cone at the end of the	Spring	Stationary
	spring and align the stationary spring		Spring cone
	cone(s) with the holes in the center
	bearing bracket. Secure the spring(s) to
	the center bearing bracket with (2)	Nylon center
	3/8”-16 x 1-1/2” hex head bolts and	bushing	SPRING
	3/8”-16 nuts.		WARNING TAGs
		Stationary
	IMPORTANT: The spring warning	Spring cone
	tag(s) supplied must be securely
	attached to the stationary spring	Center bearing bracket
	cone in plain view. Should a
	replacement spring warning tag
	be required, contact Wayne-	Torsion
	Dalton Corp. for free
		Spring
	replacements.		(2) 3/8”-16 x 1-1/2”
			hex head bolts

(2) 3/8”-16 Nuts
SPRING	WARNING TAGs
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.		17

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com