Wayne-Dalton 9800 installation instructions To avoid possible

Page 2

Table of Contents

 

Important Safety Instructions

2

Package Contents

3

Door Section Identification

4

Tools Required

4

Removing An Existing Door/ Preparing The Opening

5

Installation

6-21

Optional Installations

22-23

Side Lock

22

Pull Rope

22

Trolley Operator

23

Maintenance

24-25

Cleaning

24

Painting Instructions

25

Warranty

26

Dealer Locator Information

26

Definition of key words used in this manual:

WARNING

Indicates a potentially hazardous situation which, if not avoided, could result in severe or fatal injury.

CAUTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS.

IMPORTANT: Required step for safe and proper door operation.

NOTE: Information assuring proper installation of the door.

 

To avoid possible

WARNING

 

injury, Read these

instructions carefully before attempting installation. If in question about any of the procedures, do not perform the work. Instead, have a trained door systems technician do the installation or repairs.

1.Read and follow all installation instructions.

2.Wear protective gloves during installation to avoid possible cuts from sharp metal edges.

3.It is always recommended to wear eye protection when using tools, otherwise eye injury could result.

4.Avoid installing your new door on windy days. Door could fall during the installation causing severe or fatal injury.

5.Doors 12’ - 0” wide and over should be installed by two persons, to avoid possible injury.

6.Operate door ONLY when it is properly adjusted and free from obstructions.

7.If a door becomes hard to operate, inoperative or is damaged, immediately have necessary adjustments and/or repairs made by a trained door system technician using proper tools and instructions.

8.DO NOT stand or walk under a moving door, or permit anybody to stand or walk under an electrically operated door.

9.DO NOT place fingers or hands into open section joints when closing a door. Use lift handles/gripping points when operating door manually.

10.DO NOT permit children to operate garage door or door controls. Severe or fatal injury could result, should the child become entrapped between the door and the floor.

11.Due to constant extreme spring tension, DO NOT attempt any adjustment, repair or alteration to any part of the door, especially to springs, spring brackets, bottom corner brackets, red colored fasteners, cables or supports. To avoid possible severe or fatal injury, have any such work performed by a trained door systems technician using proper tools and instructions.

12.On electrically operated doors, pull down ropes must be removed and locks must be removed or made inoperative in the open (unlocked) position.

13.Top section of door may need to be reinforced when attaching an electric opener. Check door and/or opener manufacturer’s instructions.

14.VISUALLY inspect door and hardware monthly for worn and or broken parts. Check to ensure door operates freely.

15.Test electric opener’s safety features monthly, following opener manufacturer’s instructions.

16.NEVER hang tools, bicycles, hoses, clothing or anything else from horizontal tracks. Track systems are not intended or designed to support extra weight.

After installation is complete, fasten this manual near garage door.

2Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Light Commercial Windload To avoid possible PRE-INSTALLATION Door Section Identification Tools RequiredRemoving An Existing Door Installation Horizontal AnglesCounterbalance Cables Bars14 x 7/8 self drilling screws Vertical Track Assembly Bottom SectionStacking Sections Other side Endcap and fasten usingTop Brackets Tightened in stepProperly Operator BracketSection of the DOOR, Along Door Operation Important the DimensionTop Section Do not Raise Door Until InjuryAdjusting Top Brackets Torsion End Bearing BracketsSide Torsion Spring AssemblyCenter Bearing Bracket Nylon Center Bushing Securing Door For Spring WindingWinding Torsion Springs Systems service technicianUsing proper tools Instructions Severe or fatal injury To avoid possible severe orResult in door falling Rear SupportRaising door further can Cause severe or fatal injury24 Max 24 MaxSide Lock Pull RopeTrolley Operator Installation and MonthlyInstallation Instructions Failure to Test or Make ANYAcrylic Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorGlass Cleaning Instructions Important do not USE a Pressure Washer on Garage DoorRefinishing Steel Preparation For PaintingFiberglass Refinishing And Or Finishing
Related manuals
Manual 32 pages 11.46 Kb Manual 20 pages 42.88 Kb Manual 4 pages 60.02 Kb Manual 38 pages 17.26 Kb Manual 18 pages 4.37 Kb

9800 specifications

Wayne-Dalton is a well-known brand in the garage door industry, offering a wide range of models designed for durability, performance, and aesthetic appeal. Among its most popular series are the 9700, 5000, 8000, 9000, and 9800, each equipped with unique features and advanced technologies to meet diverse customer needs.

The Wayne-Dalton 9700 series is known for its combination of strength and insulation. This garage door is manufactured with a three-layer construction providing robust protection against the elements while offering excellent energy efficiency. The insulated steel construction can help maintain interior temperatures, making it ideal for attached garages.

The 5000 series, on the other hand, is designed for a more traditional look combined with modern performance. Featuring a lightweight design, it is made from durable materials that resist rust and corrosion. The 5000 series can be customized with different colors and styles, allowing homeowners to achieve the perfect aesthetic to enhance their property.

Moving on to the 8000 series, this model is designed for commercial applications and residential use where heavy-duty functions are necessary. It is built to withstand extreme weather conditions while providing optimal security with added strength features. The 8000 series offers smooth operation and minimal maintenance requirements, making it a great choice for those seeking reliability.

The 9000 series stands out with its stylish design and sleek finishes. This series offers advanced insulation options, coupled with numerous panel designs that provide a polished and sophisticated look. The 9000 model emphasizes both aesthetics and energy efficiency, making it a favorite among homeowners looking for a beautiful yet functional garage door.

Lastly, the 9800 series is the premium option within Wayne-Dalton’s offerings. This series is characterized by its high insulation value and thermal efficiency, thanks to its innovative construction techniques. The 9800 doors can be customized with numerous panel options and colors, delivering a luxury look while ensuring excellent performance.

In conclusion, Wayne-Dalton’s 9700, 5000, 8000, 9000, and 9800 series garage doors each feature distinctive characteristics and technologies aimed at enhancing durability, security, and aesthetics. Homeowners can find a reliable option within this range that suits their specific requirements, whether they prioritize insulation, style, or heavy-duty functionality. With Wayne-Dalton’s commitment to quality and innovation, these garage doors stand out in today’s market.
Top Page Image Contents