Wayne-Dalton 9800 installation instructions Bottom Section, Vertical Track Assembly

4	Bottom Section
Tools Needed:	Center the bottom section in the door
Level	opening. Level section using wooden
	shims (if necessary) under the bottom
	section.

Level

BOTTOM

SECTION

wooden shims (if necessary)

5	Vertical Track Assembly	Wall Angle	Clip mount (Your clip mount
Tools Needed:	IMPORTANT: The tops of the vertical		Quantity and location may vary)
Power Drill	tracks must be level from side to side.
	If the bottom section was shimmed
3/16” Drill Bit
	to level it. The vertical track on the
7/16” Socket	shimmed side, must be raised the height
	of the shim.	vertical track
Driver
	Position the left hand vertical track assembly	Assembly
Level
	over the rollers of the bottom section. Make
		5/16” x 1-5/8”
Tape Measure	sure the counterbalance cable is located
Step Ladder	between the rollers and the door jamb. Drill	LAG SCREWS	lag
	3/16” pilot holes for the lag screws. Loosely	(Your number
(Concrete		of lag	screw
	attach the wall angle to the jamb using
		screws may
Mounting)	5/16” x 1-5/8” lag screws. Tighten the bottom
		vary)
3/8” Simpson	lag screw, securing the wall angle to jamb,
			Wall
Titen HD, 2-3/4”	maintaining 5/8” track spacing between the
Min Embed Into	vertical track and bottom section. Repeat for		Angle
Min 2000 PSI	the right hand side.		vertical track
		BOTTOM
Concrete at 15”
		SECTION
O.C. Max.			BOTTOM SECTION

roller	5/8”
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.	9

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

INSTALLATION