Wayne-Dalton 9800 installation instructions 14 x 7/8 self drilling screws

Tools Needed:

To install a u-bar across the middle of a section, align the horizontal center line of the u-bar with the center line of the section.

For Windload specification option codes 1200, 1201, and 1202, all u-bars must be attached with 1 fastener at each hole location along the u-bar, which is a minimum of 10 fasteners per u-bar. Attach to section with 1/4”-14 x 1/2” self drilling screws, except at ends, which are attached with

1/4”- 14 x 7/8” self drilling screws.

For Windload specification option codes 1220 and 1221 all u-bars must be attached with 1 fastener at each hole location along the u-bar, which is a minimum of 18 fasteners per u-bar on a 16’ wide door, and a minimum of 12 fasteners per u-bar on a 10’ and a 12’ wide door. Attach to section with 1/4”-14 x 1/2” self drilling screws, except at ends, which are attached with 1/4”-14 x 7/8” self drilling screws.

9800	Windload U-bar Schedule Option Code 1221
Total		Bottom	Lock	Intermediate	Intermediate II	Top
Sections
4		2 u-bars	2 u-bars	3 u-bars		1 u-bar
5		2 u-bars	2 u-bars	2 u-bars	3 u-bars	1 u-bar

Attaching u-bar to section.

U-bar

U-bar ends fastened with (2) 1/4”-14 x 7/8” self drilling screws

U-bar fastened with 1/4”-14 x 1/2” self drilling screws in every hole location except ends

U-bar alignment lines on end caps

8Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com