Lindy Carbon Monoxide Alarm user manual Installation and Commissioning

Page 12

3	NSTALLATION AND COMMISSIONING
	I
	INSTALLATION AND COMMISSIONING
3.2	19'' installation	When installing the RMS in a rack, the additional requirements in
		accordance with IEC 950 must be observed and complied with!
		• Determine the position in which the RMS is to be located within the
		19" rack. Observe the existing number of blanking plates for a uni-
		form rack appearance.
	Caution!	Danger of overheating!
		Allow sufficient space from built-in fans or air-conditioners to
		ensure an unimpeded flow of air in the rack.hten.

Note	• Mount the RMS on sliding rails if possible.
	This makes handling the device easier and reduces wear on the rack.

If the RMS is mounted freely suspended, hold the device horizontally when tightening the screws and start with the two bottom screws.

•Mount the RMS in the desired position with 4 mounting screws, washers and nuts.

Rack

Image 12

Contents MonitoringRack MonitoringSystemSystem Rack Ccontentsontents Ccontentsontents General Information Safe WorkingWarranty Lapse of warrantyDisposal Service HotlineMail STANDARDS, RegulationsRack Monitoring LiteConnection options DigitalHumidity Sensor digitalMains Power Strips Door ContactReader Infrared Room surveillancePreparations Check the supplied itemsNecessary Tools Installation and Commissioning Electrical Installation Connections and cablingCabling Mains montoringDigital AlertUPS 10BASETCOM AUXFuses Double -pole fuse / fuse of the neutral wire Fuse for the auxiliary voltageSupply CommissioningOperator Control Elements Initial StateOperation VIA Keys on the Front of the Device Selecting a menu itemFilter messages Display in the Confirm menuEntering network parameters Operation VIA Telnet or Serial Interface COM? Help Block diagram Network Configuration IP AddressSnmp Configuration AMESnmp a Ccess Write CommunityReboot Configuration VIA Tftp Update VIA TftpTFTP-SERVER StatusUser Administration Selection pointer to next userConfigure digital outputs Digital Outputs InvertTemperature Inputs Digital InputsQuit Humidity Inputs Mains MonitoringUpdate the screen AUX Device Selection Previous Device+ Next Device Return Quit With SavingFilter Filter Selection UITSnmp Trap FfectLED W Arning DIGITAL/ALERT/UPS Inputs TEMPERATURE/MAINS/HUMIDITY Inputs ODE-A B M ODE-BSet threshold Selection pointer to next input Feedback Inputs Previous Feedback InputIlter Message LOG Preconfigured filters with an Example of filter configuration using filter 1 temperatureExamples of filter settings Example of terminal assignMonitoringRack MonitoringSystemSystem Rack Eexamplexample Configurationconfiguration Specimen output ConfigurationRack Mmalfunctionsalfunctions RemedyTechnicaltechnical Datadata Rated ambient temperatureFAQ EMCMIB RFCProduct designation ModelSystem Configuration DocumentationExplanation of the MIB For RMSIso.org.dod.internet.private.enterprises.infratec.rms Variable Type ValueObjects under Variable Type Value Access Object under ups I NT Able Variable Type Value AccessObjects under Variable Type Value Objects under outputTable Variable Type Value Objects underObjects under tempTable Objects under humidTableObjects under mainsTable Variable Type Value Objects under filterTable Variable Type ValueObjects under Variable Variable Type Value Access 6.1.4.1.1909.10.7.3Type Value Access FilterMainsTableObjects under userTable Variable Type Value Objects under aux VariableObjects under icc Variable Type Value GNU General Public RemoRack RMS Lite RMS AdvancedRack