Lindy Carbon Monoxide Alarm user manual Electrical Installation, Connections and cabling, Cabling

3IINSTALLATIONNSTALLATIONAND ANDCOMMISSIONINGCOMMISSIONING

3.3	ELECTRICAL INSTALLATION
3.3.1	Connections and cabling	1 Fuse plug > 3.3.3		temperature or humidty sensor
		2	Mains Connections > 3.3.2	connections 1-4
		3	MAINS MONITORING	8 UPS IN
		Mains monitoring connections		UPS connections 1 - 2
		4	DIGITAL OUT	9 10 BASE T
		Digital switching outputs 1 - 4		RJ45 Ethernet network connection	13
		5	DIGITAL IN	10 AUX
		Digital inputs 1 - 8		Serial interface for the control
		6	ALERT IN	and monitoring of external devices
		Alarm inputs 1 - 4		11 COM
	RMS ADVANCED	7	TEMPERATURE/HUMIDITY	Serial interface for terminal connection

1 2 3 4 5 6 7 8 9 10 11

1	2	3	4	6	8	9	10
RMS LITE			• Before connecting the RMS to the mains, properly connect all the
Connection			components to the rear of the device. Observe VDE regulations!

•Only have mains voltages connected by authorised skilled persons.

•Use wire end ferrules when connecting litz cables!

•Observe the information on documentation (> A2)!

Cabling	• Avoid tensile loads, serious kinking and damage to the cables as a
	result of sharp edges or unsuitable tools (optional cable protection avai-
	lable).
Mains montoring	– 3 terminal pairs L1, L2 and L3 for the connection of 3 mains voltages
	– Potential-free, no common earth reference
	– UIN 50 … 255 V AC
	– Only have mains voltages connected by authorised skilled persons.
	Observe VDE regulations!
Digital Out	- 4 terminal pairs for the connection of 4 consumers
	– Potential-free relay switch contacts
	– Relay 108 cycles purely mechanically, 105 cycles at maximum loads-
	witched
	– Maximum load switched 1.5 A at 230 V AC, 2 A at 30 V DC

MonitoringRack MonitoringSystemSystem