Emerson MA N-00 05-00, UT-P+-STXXXX user manual Glossary of Terms

Chapter 6 Glossary of Terms

Start Delay Uni-Tran Net Safety:	power up delay in progress
Switch On:	magnetic reed switch is activated or manual reset switch is
	activated
Calibrate Sensor:	mode for calibrating the unit
Auto Cal:	automatic calibration mode
Sensor Fault:	fault present, sensor or sensor wiring failure
(Not applicable to O2 sensor)	calibration zero gas setting in progress
Zero Set:
(Not applicable to O2 sensor)	apply 50% calibration gas
Apply 50% Span:
(Not applicable to O2 sensor)	span gas detected, automatic span gas setting in progress
Setting Span:
(Not applicable to O2 sensor)	remove calibration gas
Remove Gas:
Fail Cal. :	calibration span setting failed
(Not applicable to O2 sensor)	calibration failed, no gas detected during calibration
Time Out:
(Not applicable to O2 sensor)	Setting zero level on controller
Setting Zero:
(Not applicable to O2 sensor)	excessive negative sensor drift
Neg. Drift:
Set Relay Options:	mode for setting the alarm relay
Review Relay Settings:	mode for reviewing the alarm settings
Set Low:	set low alarm level
Set High:	set high alarm level
Coil Status:	set the coil status for relays
Energized:	relay is normally energized

31