Emerson UT-P+-STXXXX, MA N-00 05-00 user manual Ordering Information

Page 38

De-Energized:

relay is normally de-energized

Latch Status:

set the latch status of relays on alarm condition

Latching:

relay latches at alarm condition

Non-Latching:

relay does not latch in alarm condition

Low Alarm Level:

low alarm relay is activated

High Alarm Level:

high alarm relay is activated

Calibration Complete:

calibration completed successfully

(Applicable only to O2 sensor)

apply ambient air or certified instrument air

Apply Calibration Air:

(Applicable only to O2 sensor)

device is calculating the oxygen level

20.9:

(Applicable only to O2 sensor)

device is measuring the oxygen level

processing:

(Applicable only to O2 sensor)

remove instrument air if applicable

Remove Calibration Air:

Ordering Information

32

Page 37 Page 39
Image 38
Page 37 Page 39
Contents UNI-TRAN Premium Plus Toxic GAS Detector UT-P+-STXXXX Page Page Page Table of Contents Page Introduction FeaturesIntroduction Location of Sensors Installation and Start UpWhat’s in the package UnpackingMounting Toxic Detector LayoutDimensional Drawings Page Page Page Wiring Sensor Separation Page Wiring Diagrams Page Page Page Page Page Installation Checklist Start UpRelay Settings Default Relay SettingsSummary of Main Menu Exit Return to normal if no option is selectedReview Settings System CalibrationCalibration Procedure Page Operator Interface OperationPeriodic Response Check Calibration Procedure Table of ResponsesMagnetic Reed Switch Activation Relay Settings Review Settings Hardware Start DelaySensor Fault Sensor DriftRelays 20 mATroubleshooting Sensor LifeGlossary of Terms Ordering Information Published in a ccordance w ith E1A standard Appendix B Wire Resistance In Ohms AWGAppendix C Specifications Sensor SpecificationsPage
Top Page Image Contents