Appendix
Troubleshooting
Problem: Smell of gas is present
Solution: Check for loose connections in the gas line. Perform a leak test following the procedure on page 9.
Problem: Burner does not ignite
Solution: Use the following procedure with the figure below.
Check the position of the sparker tip. It should be point- ing forward towards the front of the burner.
•Make sure there is a blue spark at the electrode tip to the burner.
•Make sure the igniter wire is connected firmly to the valve ignition device and the electrode.
•Make sure the valve orifice is free of any debris, dust or grease.
•Make sure the valve orifice is aligned inside the front hole of the burner.
•If there is no spark at all, replace the electrode or igniter wire.
Note: Turn off the gas at the source while troubleshoot- ing.
23 Appendix
Power Burner
LTR50001100, Rev. A | www.calflamebbq.com |