Cal Flame BBQ11955P manual Cabinet Cut-out Dimensions

Page 7

Cabinet Cut-out Dimensions

Your Cal Flame Power Burner is designed for easy installation into a non-combustible enclosure. The supporting deck or counter must be flat and level.

Width	Depth	Height

18”	20”	9 ¼”

WIDTH DEPTH

HEIGHT

Power Burner

Installation / Assembly

LTR50001100, Rev. A

www.calflamebbq.com

Image 7

Contents

Page Appendix Installation / AssemblyUsing Your Power Burner Cleaning and Maintenance Cal Flame Power Burner is designed for outdoor use only Placement and Location Set-Up What To Do If You Smell Gas OperationPrecautions Regarding Children Maintenance and RepairStorage Converting the Power Burner Installation / AssemblyCabinet Cut-out Dimensions LP Gas Cylinder SpecificationTank Requirements Transporting and Storing LP Gas LP Gas Hook UpRequirements Natural GasConnection Leak Testing Procedure Placing the Power Burner in a Built-in Enclosure Power Burner Controls Using Your Power BurnerBasic Operation Electronic Ignition Lighting the Power BurnerManual Lighting Power Burner Lid Must always be in place during operation Using the Wok RingRemoval Removing and Replacing BurnersReplacement Stainless Steel Care and Cleaning CLR Cleaning Products and MaterialsFire CleanRinse PolishBurners Rust RemovalSteam Cleaning Your Power Burner Covering Your Power BurnerDrip Pan Problem Smell of gas is present TroubleshootingProblem Burner does not ignite Problem Yellow Flame Problem Plugged orificeProblem Burner tube is misaligned over the orifice Problem Obstruction in the gas lineProblem Flashback Problem Misalignment of Igniter on BurnerYou must perform both steps Converting from LP to NGNot provided Switching the regulatorAppendix Changing the burner orificesOrifice sizes Inner burner Outer burner Mark the rating plateWarranty Limitations Limited WarrantyExtent of Warranty Warranty PerformanceDisclaimers Legal Remedies Customer ServicePower Burner Don’t forget to register your new product at Locating the Product Serial Number