12. Boiler Jacket Assembly:
NOTE: All piping, boiler controls, gauges and valves must be installed before the jacket has been assembled on the boiler. Refer to the following page to clarify these boiler jacket assembly instructions.
Insert the separate piece of insulation (# 92) on top of boiler so the entire top and sides of boiler are covered. Use plastic strapping to secure the insulation in place. Mount the panel installation bracket (#82) onto the draw-rods on the upper front of the boiler. Install the six spacers (#86) onto the draw-rods. Two on the upper draw rods in the front and the remaining spacers onto the draw-rods in the back of the boiler. Install the rear insulation (#101) onto the boiler. Place the side panels (#66,52) onto the boiler making sure the draw rod spacers are between the side panels and the boiler casting. Tighten the sides of the casing to the panel installation bracket (#82) using sheet metal screws. Screw two studs (#90) into the bottom front of the boiler and screw on the threaded hex spacers (#87) onto the studs. Attach the lower mounting bracket (#83) to the boiler by using two bolts (#89) and screw- ing them into the threaded hex spacers. Then using sheet metal screws, attach the lower mounting bracket to the sides of the casing. Slide the control panel (#110) onto the casing from the top and se- cure it to the control panel support (#82) using sheet metal screws. Attach the rear panels (#84,85) using sheet metal screws. Place the top panel (#76) onto the sides of the casing and assure that the pins on the sides are aligned with the retaining holes on the top casing panel. Finally attach the front panel (#81) onto the casing by aligning the retaining pins with the retaining holes. Push to insure a positive connection.
Boiler Components &
76
Parts Vega B40 - Series
Boiler Jacket Assembly:
Part# Description
84,85 — Rear Jacket Panels*1
92,101— Insulation
52— Right Jacket Panel
66— Left Jacket Panel
83— Front Jacket Supports
110— Control Panel
82— Control Panel Support
76— Top Jacket Panel
81— Front Jacket Panel*2
Rear insulation not attached, but included with the casing Front insulation attached to the casing