Design Dynamics VTD-18N-PDG installation manual Gas leak. See Warning, See Checking Gas Connec

Page 18

troubleshooting

Continued

WARNING: If you smell gas

Shut off gas supply.

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM

POSSIBLE CAUSE

REMEDY

 

 

 

 

 

Heater produces unwanted

1. Heater burning vapors from

1.

Open flue to maximum. Stop

odors

 

paint, hair spray, glues, clean-

 

using odor causing products

 

 

ers, chemicals, new carpet,

 

while heater is running

 

 

etc. (See IMPORTANT state-

 

 

 

 

2.

ment above)

2.

Refill supply tank (propane/LP

 

Low fuel supply (propane/LP

 

3.

only)

3.

only)

 

Gas leak. See Warning

Locate and correct all leaks

 

 

statement at top of page

 

(see Checking Gas Connec-

 

 

 

 

tions, page 9)

 

 

 

 

 

Heater shuts off in use (ODS

1. Not enough fresh air is avail-

1.

Open window and/or door for

operates)

2.

able

2.

ventilation

 

Low line pressure

Contact local natural or pro-

 

3.

ODS/pilot is partially

3.

pane/LP gas company

 

Clean ODS/pilot (see Cleaning

 

 

clogged

 

and Maintenance, page 14)

 

 

 

 

 

Gas odor even when control knob

1. Gas leak. See Warning

1.

Locate and correct all leaks

is in OFF position

 

statement at top of page

 

(see Checking Gas Connec-

 

2.

Control valve or gas control

2.

tions, page 9)

 

Replace control valve or gas

 

 

defective

 

control

 

Gas odor during combustion

1. Foreign matter between con-

1.

Take apart gas tubing and

 

2.

trol valve and burner

2.

remove foreign matter

 

Gas leak. See Warning

Locate and correct all leaks

 

 

statement at top of page

 

(see Checking Gas Connec-

 

 

 

 

tions, page 9)

18

www.desatech.com

111826-02J

Image 18
Contents What to do if YOU Smell GAS Table of Contents Safety Information Local Codes High traffic areas Windy or drafty areasProduct Identification Product FeaturesOptional Remote Control Accessories UnpackingVenting specifications for installation InstallationInstallation and Clearances Flue Opening SpecificationsConnecting to gas supply Installing Damper ClampInstalling Heater Assembly Installation Items NeededInstallation Natural GasPropane/LP Gas Checking gas connections Test Pressures Equal To or Less Than Psig 3.5 kPaFor your safety Read before lighting Pressure Testing Heater Gas ConnectionsOperating Heater Lighting Instructions Control KnobTo Turn OFF GAS To Appliance Manual Lighting ProcedureOptional Hand-held Remote control OperationInspecting Burners Pilot Flame PatternBurner Flame Pattern Cleaning Maintenance SpecificationsWiring Diagram Troubleshooting Observed Problem Possible Cause RemedyODS/pilot lights but flame goes See Cleaning and Mainte Gas leak. See Warning See Checking Gas ConnecReplacement Parts Service HintsTechnical Service AccessoriesIllustrated Parts Breakdown Models vTD-18n-Pdg, vtd-18p-Pdg, vtd-18N-BTB and vtd-18P-BTBParts List Illustrated Parts Breakdown Models vtd-24n-Pdg, vtd-24p-Pdg, vtd-24N-BTB and vtd-24P-BTBVenturi/Shutter Assembly Warranty Information Keep this WarrantyLimited Warranty Vented GAS LOG Heaters