Product
Identification
Electronic | Log Set Assembly |
| |
Ignitor |
|
Control
Knob
Flame |
|
|
| |
Adjustment |
|
| ||
Knob | Selector |
|
| |
| Switch |
|
| |
Remote | Chassis | |||
Assembly | ||||
Remote Control | Receiver | |||
| ||||
BTB Models
Log Set
Assembly
Electronic
Ignitor
Control
Knob Selector
Switch
FlameChassis
Adjustment Assembly
Knob
PDG Models
Figure 1 - Product Identification
Unpacking
CAUTION: Do not remove the data plates from the grate as- sembly. The data plates contain important warranty and safety information.
1.Remove log set assembly from carton. Note: Do not pick up assembly by logs. This could damage heater. Always handle assembly by grate.
2.Remove control cover floor media components.
3.Remove all protective packaging applied to log set for shipment.
3.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought heater.
Product Features
Operation
This unitized gas log set is tested and approved to ANSI Z21.60a and CSA
Safety Device
This heater has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot shuts off the heater if there is not enough fresh air.
Electronic Ignition System
This system has an electronic ignitor. This system requires no matches or other sources to light heater. Receiver requires 4 AA batteries (included), hand- held remote control requires a
Optional Remote
Control Accessories
There are two optional remote accessories available for the PDG log set models that come standard with the BTB log set models:
•wall switch
•