Emerson HD7005, HD7002 owner manual Check for possible leaks by performing the following

Water Fill (continued)

To fill this humidifier, close the control cover and remove the bottle cover. To remove the water bottle, lift the bottle straight up and out of the cabinet.

The water bottle is designed with an “E-Z- Fill Side-Cap”. Remove the “E-Z-Fill Side- Cap” on the side of the water bottle by twist- ing counterclockwise.

Place the opening of the water bottle under a water faucet (the bottle should fit under a four-inch clearance faucet). Fill the water bottle. Use only clear cold water. Solid debris could make the valve leak.

Install the fill cap by twisting clockwise. Hand tighten only.

Check for possible leaks by performing the following:

1.Grasp bottle handle and hold the bottle upright over sink.

2.Press up on valve cap plunger for about one second to let out a little water.

3.Release the plunger.

4.Listen for air bubbles. Look for leaks around fill cap.

5.If you hear air bubbles or see leaks, retighten cap and check for leaks again.

NOTE: If either the fill cap or the valve cap leaks, water may overflow and leak out the rear vents of the cabinet.

Wipe off excess water from the bottle.

Position the water bottle back into the unit. Grasp the water bottle handle, and lower into the cabinet. For proper operation, the “E-Z-Fill Side-Cap” must be facing the cen- ter of the cabinet. When positioned proper- ly, the plunger will open and water will flow into the cabinet. The water level will auto- matically remain at approximately 1" until the bottle is empty. The unit is now ready for operation.

Turn Counterclockwise

to Remove “E-Z-Fill Side-Cap

Valve Cap

Plunger

6