Kidde PI2000CA manual Operation, Battery, Testing

Installation

Battery

This unit will not function without a properly installed battery. When installing a battery, press the battery reminder tab down into the battery compartment and install the battery (See Image 6A and 6B). For initial installation a pre-installed 9 V battery is included with a battery pull tab that allows for easy connection.

CAUTION: If the battery reminder tab is not held down in the battery compartment by the battery, the battery door will not close and the unit will not attach to the mounting plate.

Battery

tab

Testing

•After installation, test your alarm by depressing and holding down the test button for 5 seconds or until the alarm sounds.

CAUTION: Due to the loudness (85 decibels) of the alarm, always stand an arms-length away from the unit when testing.

Operation

The smoke alarm is operating once a fresh battery is installed and testing is complete. When the smoke alarm ionization sensor chamber senses products of combustion, the horn will sound a loud (85 db) alarm until the sensing chamber is cleared of smoke particles.

12