Kidde PI2000CA manual Fire Safety, Limitations of Smoke Alarms

Page 20

Fire Safety

Limitations of Smoke Alarms

WARNING: Please read carefully and thoroughly.

NFPA 72 states: Life safety from fire in residential occupancies is based primarily on early notification to occupants of the need to escape, followed by the appropriate egress actions by those occupants. Fire warning systems for dwelling units are capable of protecting about half of the occupants in potentially fatal fires. Victims are often intimate with the fire, too old or young, or physically or mentally impaired such that they cannot escape even when warned early enough that escape should be possible. For these people, other strategies such as protection-in-place or assisted escape or rescue are necessary.

Smoke alarms are devices that can provide early warning of possible fires at a reasonable cost; however, alarms have sensing limitations. Ionization sensing alarms may detect invisible fire particles (associated with fast flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may detect visible fire particles (associated with slow, smouldering fires) sooner than ionization alarms. Home fires develop in different ways and are often unpredictable. For maximum protection, Kidde recommends that both ionization and photoelectric alarms be installed.

A battery powered alarm must have a battery of the specified type, in good condition and installed properly.

AC powered alarms (without battery backup) will not operate if the AC power has been cut off, such as by an electrical fire or an open fuse.

Smoke alarms must be tested regularly to make sure the batteries and the alarm circuits are in good operating condition.

Smoke alarms cannot provide an alarm if smoke does not reach the alarm. Therefore, smoke alarms may not sense fires starting in chimneys, walls, on roofs, on the other side of a closed door or on a different floor.

If the alarm is located outside the bedroom or on a different floor, it may not wake up a sound sleeper.

19

Image 20 Contents
Dual Sensor Contents IntroductionInstallation HD135FCARecommended Locations Image 1A Image 1B Locations to Avoid Ceilingminimum Wiring Requirements Mobile HomesWiring Instructions Wires on Alarm Harness Mounting Image 5 Attaching the AC QUICK-CONNECT Wire Harness Operation BatteryTesting Hush Control Feature Alarm Tamper-Resist Feature LED Indicators Smoke Sensing Chamber OperationAlarm Memory When Units Are InterconnectedBattery Replacement MaintenanceAlarm Removal Cleaning the Alarm Replacing the AlarmFire Safety Limitations of Smoke AlarmsGood Safety Habits What To Do When The Alarm Sounds NRC InformationAdditional Recommendations Warranty Year Limited Warranty