Hearth and Home Technologies FB-GRAND-S, FB-IN-S owner manual Installation Preparation

Page 11

6 Installation Preparation

Prepare the existing solid fuel masonry or factory built non-combustible firebox for installation.

A. Flue Damper

Fully lock the solid fuel fireplace’s flue damper in the open position, OR completely remove it.

E. Fireplace Conversion Notice

Permanently attach the label with the following warning to the inside lower back of the fireplace firebox into which the insert is being installed. Silicone may be required to properly secure the label.

B. Chimney

•Ensure chimney is constructed of non-combustible materials.

•Ensure chimney is clean and in good working order.

•Ensure that all chimney cleanouts fit properly to prevent air leakage into chimney.

C. Gas Line

Note: If the factory built fireplace has no gas access hole provided, an access hole of 1 inch (25 mm) diameter or less may be drilled through the lower sides or bottom of the firebox in a proper workmanship - like manner. This access hole must be plugged with non-combustible insulation after the gas supply line has been installed.

•Install gas line into firebox cavity.

•Check local codes and gas line sizing requirements following NFPA54. See Section 8.

WARNING

Fire Risk.

This fireplace has been converted for use with a gas fireplace insert only and cannot be used for burning wood or solid fuels unless all original parts have been replaced, and the fireplace re- approved by the authority having jurisdiction.

Prior to installing the gas insert:

•Have the chimney and adjacent structure inspected and cleaned by qualified professionals. Hearth & Home Technologies recommends that NFI or CSIA certified professionals, or technicians under the direction of certi- fied professionals, conduct a minimum of a NFPA 211 Level 2 inspection of the chimney.

•Replace component parts of the chimney and fireplace as specified by the professionals.

•Ensure all joints are properly engaged and the chimney is properly secured.

D. Hearth or Hearth Extension

WARNING

Fire Risk.

A hearth or hearth extension (if present) must comply with either of the following:

•The solid fuel burning fireplace manufacturer’s specification.

• Local building codes required by authority having jurisdiction.

• NFPA 211

F. Remote Control

The receiver for the remotes must be installed BETWEEN

the base pan of the insert and the firebox of the wood- burning fireplace (see photo below).

EXISTING SIDE

REFRACTORY

REMOTE

RECEIVER

UNIT

EXISTING BOTTOM OF

FIREPLACE

Heat & Glo • FB-IN-S, FB-GRAND-S • 783-910 Rev. G • 11/08

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents FB-GRAND-S FB-IN-S ModelsHomeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Tools and Supplies Needed Design and Installation ConsiderationsGetting Started Inspect Appliance and ComponentsInspect Firebox Inches Millimeters Fireplace Size RequirementsMinimum Fireplace Opening LocationClearances to Mantels or other Combustibles above Appliance ClearancesFoot minimum in snow regions Termination LocationsVent Termination Minimum Clearances Fire Risk Asphyxiation RiskMeasuring Standards Vent Information and DiagramsVent Table Key Horizontal VentingInstallation Preparation Venting Components Installing Vent Pipe and ApplianceConnecting Vent Pipe Placing, Securing and Leveling the Appliance Damper Flashing Kit Optional Installing Adaptor and Termination CapMasonry Factory Built Wood BurningMinimum inlet pressure Gas InformationFuel Conversions Gas Connection Gas PressuresHigh Altitude Installations Appliance Requirements Wiring the ApplianceON/OFF Switch Electrical InformationShock hazard Junction Box InstallationInstallation for Fan Optional Optional AccessoriesFAN Junction BOX Mantel Projections Installing Trim SurroundsFinishing Ember Placement Appliance SetupClean the Appliance AccessoriesLogs Locating Tabs Grate Assembly Heat & Glo FB-IN-S, FB-GRAND-S 783-910 Rev. G 11/08 Instructions Positioning the Logs Model FB-IN-SLOG PlacementFlat Spot for Log #4 Replacing Glass Assembly Glass AssemblyAir Shutter Setting Removing Glass AssemblyBefore operating this appliance have a qualified technician Operating InstructionsBefore Lighting Appliance Standing Pilot Ignition Lighting ApplianceDo not operate appliance with glass door removed Initial Break-in ProcedureCheck Pilot Flame Appearance After Appliance is LitFrequently Asked Questions Standing Pilot Ignition System TroubleshootingSymptom Possible Causes Corrective Action Maximum flame impingement. Follow lighting instruc TroubleshootingSymptom Possible Cause Corrective Action Risk of injury or property damage Maintenance TasksMaintaining and Servicing Appliance Inspect Maintenance Tasks Reference Materials Appliance Dimension DiagramDirect Vent Flex Liner Kits Vent Kits ComponentsPart number list on following Log Set AssemblyService Parts Be ordered from an authorized dealer At DepotFB-IN-S GLA-FBIN Stocked FB-GRAND-S, FB-IN-SCONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Important operating Contact Information

FB-GRAND-S, FB-IN-S specifications

Hearth and Home Technologies has consistently been at the forefront of innovation in the fireplace industry, and their FB-IN-S and FB-GRAND-S models exemplify this commitment to quality, efficiency, and style. Designed for modern living spaces, these products bring both aesthetic appeal and practicality to homeowners looking to enhance their environment with a sleek, efficient heating solution.

The FB-IN-S model is a testament to contemporary design, featuring a minimalist facade that fits seamlessly into any decor. Its built-in installation ensures that homeowners can create a clean and unobtrusive look, making it a great choice for those who prefer a more integrated approach to their heating solutions. The FB-IN-S is equipped with an advanced combustion technology that maximizes heat output while minimizing emissions, leading to a cleaner and more efficient burn. This model also features an easy-to-use electronic ignition system, allowing for quick starts and easy operation.

In contrast, the FB-GRAND-S model offers a grander experience with its expansive viewing area and larger firebox. This fireplace is perfect for those who want to make a statement in their living space. The large glass panel showcases the flickering flames, providing a mesmerizing visual that serves as a focal point in any room. The FB-GRAND-S shares the advanced combustion system with its counterpart, ensuring optimal efficiency and reduced environmental impact.

Both models boast high energy efficiency ratings, meaning they can provide warmth without significantly increasing energy costs. Hearth and Home Technologies has incorporated Smart Technology into these fireplaces, allowing users to control their unit remotely via smartphone apps. This feature adds a layer of convenience, enabling adjustments from anywhere in the home.

Safety is paramount, and both the FB-IN-S and FB-GRAND-S come with built-in safety features, such as a sealed combustion chamber and a safety shut-off system, ensuring peace of mind for users.

In summary, Hearth and Home Technologies' FB-IN-S and FB-GRAND-S fireplaces blend beauty and functionality. With modern designs, advanced heating technologies, and smart features, these models are perfect for anyone looking to elevate their home while enjoying efficient and stylish heating solutions. Whether opting for the subtle elegance of the FB-IN-S or the striking presence of the FB-GRAND-S, homeowners can trust Hearth and Home Technologies to deliver quality and performance.
Top Page Image Contents