Hearth and Home Technologies FB-IN-S Junction Box Installation, Installation for Fan Optional

Page 18

B. Junction Box Installation

 

INSERT STRAIN RELIEF

 

AROUND CORD IN THIS END

FEED PLUG

FROM OUTSIDE OF UNIT

 

THROUGH HOLE

SIDEWALL

 

JUNCTION

 

BOX

 

SCREW

 

PROVIDED

 

Figure 9.2 Junction box installation

 

Optional Accessories

Connecting the electrical junction box is required if using a blower or remote.

•Plug the cord into a convenient outlet.

•An electrician may install an outlet box inside the fireplace. Place the outlet in the lower, back corner of the fireplace.

•Must use cord supplied.

CAUTION

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock hazard.

•Replace damaged wire with type 105º C rated wire.

•Wire must have high temperature insulation.

C. Installation for Fan (Optional)

On units already installed removal of decorative front, surround and gas insert is required.

•Detach flexible liner from back of unit if insert is installed.

•Remove the four screws on the cover plate (see Figure 9.3).

 

FAN

COVER

 

 

PLATE

POWER

GROUND

 

WIRE

 

CORD

 

 

Figure 9.3

 

 

•Bend up the tabs on the base pan (see Figure 9.4).

•Place the blower in between the bend up tabs.

•Install and wire the blower per instruction shipped with the fan.

•The ground wire of the fan can clip on the side of the base pan.

•Reinstall the cover plate back on the unit. Make sure the fan does not make contact with the back wall to prevent noise from vibration.

18

Heat & Glo • FB-IN-S, FB-GRAND-S • 783-910 Rev. G • 11/08

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Models FB-GRAND-S FB-IN-SCongratulations Homeowner Reference InformationTable of Contents Listing and Code Approvals Inspect Appliance and Components Design and Installation ConsiderationsGetting Started Tools and Supplies NeededInspect Firebox Location Fireplace Size RequirementsMinimum Fireplace Opening Inches MillimetersClearances Clearances to Mantels or other Combustibles above ApplianceFire Risk Asphyxiation Risk Termination LocationsVent Termination Minimum Clearances Foot minimum in snow regionsHorizontal Venting Vent Information and DiagramsVent Table Key Measuring StandardsInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVenting Components Placing, Securing and Leveling the Appliance Factory Built Wood Burning Installing Adaptor and Termination CapMasonry Damper Flashing Kit OptionalGas Pressures Gas InformationFuel Conversions Gas Connection Minimum inlet pressureHigh Altitude Installations Electrical Information Wiring the ApplianceON/OFF Switch Appliance RequirementsOptional Accessories Junction Box InstallationInstallation for Fan Optional Shock hazardFAN Junction BOX Installing Trim Surrounds FinishingMantel Projections Accessories Appliance SetupClean the Appliance Ember PlacementLogs Locating Tabs Grate Assembly Heat & Glo FB-IN-S, FB-GRAND-S 783-910 Rev. G 11/08 Positioning the Logs Model FB-IN-SLOG Placement InstructionsFlat Spot for Log #4 Removing Glass Assembly Glass AssemblyAir Shutter Setting Replacing Glass AssemblyOperating Instructions Before Lighting ApplianceBefore operating this appliance have a qualified technician Lighting Appliance Standing Pilot IgnitionAfter Appliance is Lit Initial Break-in ProcedureCheck Pilot Flame Appearance Do not operate appliance with glass door removedFrequently Asked Questions Troubleshooting Symptom Possible Causes Corrective ActionStanding Pilot Ignition System Troubleshooting Symptom Possible Cause Corrective ActionMaximum flame impingement. Follow lighting instruc Maintenance Tasks Maintaining and Servicing ApplianceRisk of injury or property damage Inspect Maintenance Tasks Appliance Dimension Diagram Reference MaterialsVent Kits Components Direct Vent Flex Liner KitsLog Set Assembly Service PartsPart number list on following At Depot Be ordered from an authorized dealerFB-IN-S GLA-FBIN FB-GRAND-S, FB-IN-S StockedCONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Contact Information Important operating

FB-GRAND-S, FB-IN-S specifications

Hearth and Home Technologies has consistently been at the forefront of innovation in the fireplace industry, and their FB-IN-S and FB-GRAND-S models exemplify this commitment to quality, efficiency, and style. Designed for modern living spaces, these products bring both aesthetic appeal and practicality to homeowners looking to enhance their environment with a sleek, efficient heating solution.

The FB-IN-S model is a testament to contemporary design, featuring a minimalist facade that fits seamlessly into any decor. Its built-in installation ensures that homeowners can create a clean and unobtrusive look, making it a great choice for those who prefer a more integrated approach to their heating solutions. The FB-IN-S is equipped with an advanced combustion technology that maximizes heat output while minimizing emissions, leading to a cleaner and more efficient burn. This model also features an easy-to-use electronic ignition system, allowing for quick starts and easy operation.

In contrast, the FB-GRAND-S model offers a grander experience with its expansive viewing area and larger firebox. This fireplace is perfect for those who want to make a statement in their living space. The large glass panel showcases the flickering flames, providing a mesmerizing visual that serves as a focal point in any room. The FB-GRAND-S shares the advanced combustion system with its counterpart, ensuring optimal efficiency and reduced environmental impact.

Both models boast high energy efficiency ratings, meaning they can provide warmth without significantly increasing energy costs. Hearth and Home Technologies has incorporated Smart Technology into these fireplaces, allowing users to control their unit remotely via smartphone apps. This feature adds a layer of convenience, enabling adjustments from anywhere in the home.

Safety is paramount, and both the FB-IN-S and FB-GRAND-S come with built-in safety features, such as a sealed combustion chamber and a safety shut-off system, ensuring peace of mind for users.

In summary, Hearth and Home Technologies' FB-IN-S and FB-GRAND-S fireplaces blend beauty and functionality. With modern designs, advanced heating technologies, and smart features, these models are perfect for anyone looking to elevate their home while enjoying efficient and stylish heating solutions. Whether opting for the subtle elegance of the FB-IN-S or the striking presence of the FB-GRAND-S, homeowners can trust Hearth and Home Technologies to deliver quality and performance.
Top Page Image Contents