Hearth and Home Technologies FB-GRAND-S, FB-IN-S Placing, Securing and Leveling the Appliance

Page 13

CUT AND BEND

FLASHING AS NEEDED

TO FIT CHIMNEY

SEALANT

ADHESIVE

Figure 7.2

•Trim chimney top plate to minimize excess overhang or bend over flue tile (see Figure 7.2).

•Place 3/8 inch bead of 300º F silicone on flue tile top.

C.Placing, Securing and Leveling the Appliance

•Install insert (without surround attached) into existing fireplace while pulling collar slide plate forward.

•Install gas line into hole provided on insert side.

•If applicable install remote control wires into insert side (see Section 6, F.).

•Secure collar slide plate to appliance by placing locking handle into position with locking tabs (see Figure 7.1) and secure with #8 screw.

•Level the appliance from side to side and front to back. If necessary, use the leveling legs included with the insert to set each corner of the base.

•Position any excess flexible vent pipe back up into chimney without sagging. Twist and push flex vent together to shorten.

•Install fiberglass insulation pieces to back face of surround.

•Attach surround. Follow instructions accompanying surround.

•Push insert so that surround becomes tight against face of fireplace.

WARNING

Fire Risk.

Only an approved Hearth & Home Technologies surround may be used to cover integral grills on solid fuel burning fireplaces.

• No other components such as shrouds, sheet- metal plates, etc., may be used to seal off vents.

WARNING

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

WARNING

Explosion Risk.

Combustion Fume Risk.

•Connect vent sections per installation instructions.

•The 3 foot section of stainless steel flexible pipe MUST be attached directly to the exhaust collar on the collar slide plate.

•Connect exhaust vent pipe ONLY to exhaust starting collar and termination cap center collar.

•Connect inlet air vent ONLY to inlet air collar on appliance and either the termination cap inlet air collar OR terminate within chimney.

•Do NOT allow vent to sag below connection point to appliance.

Heat & Glo • FB-IN-S, FB-GRAND-S • 783-910 Rev. G • 11/08

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents FB-GRAND-S FB-IN-S ModelsHomeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Getting Started Design and Installation ConsiderationsInspect Appliance and Components Tools and Supplies NeededInspect Firebox Minimum Fireplace Opening Fireplace Size RequirementsLocation Inches MillimetersClearances to Mantels or other Combustibles above Appliance ClearancesVent Termination Minimum Clearances Termination LocationsFire Risk Asphyxiation Risk Foot minimum in snow regionsVent Table Key Vent Information and DiagramsHorizontal Venting Measuring StandardsInstallation Preparation Connecting Vent Pipe Installing Vent Pipe and ApplianceVenting Components Placing, Securing and Leveling the Appliance Masonry Installing Adaptor and Termination CapFactory Built Wood Burning Damper Flashing Kit OptionalFuel Conversions Gas Connection Gas InformationGas Pressures Minimum inlet pressureHigh Altitude Installations ON/OFF Switch Wiring the ApplianceElectrical Information Appliance RequirementsInstallation for Fan Optional Junction Box InstallationOptional Accessories Shock hazardFAN Junction BOX Finishing Installing Trim SurroundsMantel Projections Clean the Appliance Appliance SetupAccessories Ember PlacementLogs Locating Tabs Grate Assembly Heat & Glo FB-IN-S, FB-GRAND-S 783-910 Rev. G 11/08 Instructions Positioning the Logs Model FB-IN-SLOG PlacementFlat Spot for Log #4 Air Shutter Setting Glass AssemblyRemoving Glass Assembly Replacing Glass AssemblyBefore Lighting Appliance Operating InstructionsBefore operating this appliance have a qualified technician Standing Pilot Ignition Lighting ApplianceCheck Pilot Flame Appearance Initial Break-in ProcedureAfter Appliance is Lit Do not operate appliance with glass door removedFrequently Asked Questions Symptom Possible Causes Corrective Action TroubleshootingStanding Pilot Ignition System Symptom Possible Cause Corrective Action TroubleshootingMaximum flame impingement. Follow lighting instruc Maintaining and Servicing Appliance Maintenance TasksRisk of injury or property damage Inspect Maintenance Tasks Reference Materials Appliance Dimension DiagramDirect Vent Flex Liner Kits Vent Kits ComponentsService Parts Log Set AssemblyPart number list on following Be ordered from an authorized dealer At DepotFB-IN-S GLA-FBIN Stocked FB-GRAND-S, FB-IN-SCONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Important operating Contact Information

FB-GRAND-S, FB-IN-S specifications

Hearth and Home Technologies has consistently been at the forefront of innovation in the fireplace industry, and their FB-IN-S and FB-GRAND-S models exemplify this commitment to quality, efficiency, and style. Designed for modern living spaces, these products bring both aesthetic appeal and practicality to homeowners looking to enhance their environment with a sleek, efficient heating solution.

The FB-IN-S model is a testament to contemporary design, featuring a minimalist facade that fits seamlessly into any decor. Its built-in installation ensures that homeowners can create a clean and unobtrusive look, making it a great choice for those who prefer a more integrated approach to their heating solutions. The FB-IN-S is equipped with an advanced combustion technology that maximizes heat output while minimizing emissions, leading to a cleaner and more efficient burn. This model also features an easy-to-use electronic ignition system, allowing for quick starts and easy operation.

In contrast, the FB-GRAND-S model offers a grander experience with its expansive viewing area and larger firebox. This fireplace is perfect for those who want to make a statement in their living space. The large glass panel showcases the flickering flames, providing a mesmerizing visual that serves as a focal point in any room. The FB-GRAND-S shares the advanced combustion system with its counterpart, ensuring optimal efficiency and reduced environmental impact.

Both models boast high energy efficiency ratings, meaning they can provide warmth without significantly increasing energy costs. Hearth and Home Technologies has incorporated Smart Technology into these fireplaces, allowing users to control their unit remotely via smartphone apps. This feature adds a layer of convenience, enabling adjustments from anywhere in the home.

Safety is paramount, and both the FB-IN-S and FB-GRAND-S come with built-in safety features, such as a sealed combustion chamber and a safety shut-off system, ensuring peace of mind for users.

In summary, Hearth and Home Technologies' FB-IN-S and FB-GRAND-S fireplaces blend beauty and functionality. With modern designs, advanced heating technologies, and smart features, these models are perfect for anyone looking to elevate their home while enjoying efficient and stylish heating solutions. Whether opting for the subtle elegance of the FB-IN-S or the striking presence of the FB-GRAND-S, homeowners can trust Hearth and Home Technologies to deliver quality and performance.
Top Page Image Contents