Hearth and Home Technologies CB4236IR, CB4842IR owner manual For Your Safety Read Before Lighting

Page 10

J. Lighting Instructions (IPI)

•For normal use, activate/deactivate your fireplace with the wall switch or remote control.

•The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. To prolong battery life, remove them when using the transformer.

•If your fireplace must be deactivated for serviced or an extended period of time, follow the instructions below.

FOR YOUR SAFETY READ BEFORE LIGHTING

 

WARNING:

If you do not follow these instructions exactly, a fire

 

 

 

 

 

or explosion may result causing property damage,

 

 

 

personal injury or loss of life.

 

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

This appliance must be installed in accordance with local codes, if any; if not, follow ANSI Z223.1 or, in Canada, current CAN/CGA-B149.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in and move the gas control valve or turn the gas control knob. Never use tools. If the lever or knob will not move by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

This appliance must be properly connected to a venting system in accordance with the manufacturer's installation instructions.

WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner's information manual provided with the appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier.

CAUTION:

LIGHTING INSTRUCTIONS

1.

STOP! Read the safety information above on this label.

5.

Wait five minutes to clear out any gas. If you then smell gas, STOP!

2.

Turn wall switch to the "OFF" position or thermostat to the

 

Follow "B" in the safety information above on this label. If you don't

 

lowest setting.

 

smell gas, go to the next step.

3.

Turn off all electric power to the appliance.

6.

To turn on the burner, turn on all electric power to this appliance and

4.

This appliance is equipped with an ignition device which

 

turn on the wall switch or set the thermostat to the desired setting.

 

automatically lights the pilot. Do NOT try to light the pilot by

7.

If the appliance will not operate, follow the instructions "TO TURN OFF

 

hand.

 

GAS TO APPLIANCE" and call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.

Turn off wall switch or set thermostat to lowest setting.

3.

Push the gas control lever in and move to the "OFF" position

2.

Turn off all electric power to the appliance if service is to be

 

or push the gas control lever to the "OFF" position. Do not

 

performed.

 

force.

 

 

4.

Replace the control access panel.

Due to high surface temperatures, keep children, clothing and furniture away.

Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.

33631D

Hot while in operation. Do

not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.

WARNING RISK OF FIRE

This appliance is intended to burn a specified gas fuel only. Do not attempt to use with solid wood fuel or another type of fuel. Do not attempt to modify or use any other type of gas burner system.

WARNING: Disconnect the electric power before servicing. If for any reason the original wire supplied with the appliance must be replaced, it must be replaced with 105° C or its equivalent.

For use with natural gas or propane. A conversion kit as supplied by the manufacturer shall be used to convert this appliance to the alternative fuel.

*Also certified for installation in a bedroom or a bed-sitting room.

*For U.S. only!

NATURAL GAS

10

Heatilator • Caliber BV Series • 4040-262 Rev J • 10/08

Page 9 Page 11
Image 10
Page 9 Page 11
Contents What to do if you smell gas Models CB4236IR CB4842IR Vent Gas ApplianceHot glass will cause burns Congratulations Homeowner Reference InformationInstaller Guide Table of ContentsUser Guide Troubleshooting Warranty Hearth & Home Technologies Limited Warranty CONDITIONS, Exclusions & Limitation of LiabilityWarranty Listing and Code Approvals Operating Instructions Gas Fireplace SafetyYour Fireplace Fan Kit optional Fixed Glass AssemblyRemote Controls, Wall Controls and Wall Switches Clear SpaceFor Your Safety Read Before Lighting Lighting Instructions IPIFrequently Asked Questions After Fireplace is LitMaintenance and Service Maintenance Tasks-HomeownerMaintenance Tasks-Qualified Service Technician Gasket Seal and Glass Assembly InspectionGetting Started Typical Appliance SystemInspect Appliance and Components Design and Installation ConsiderationsTools and Supplies Needed Any such action may cause a fire hazardNegative Pressure Constructing the Appliance Chase Framing and ClearancesSelecting Appliance Location Model #Clearances Rough Opening Model Width Height DepthMantel and Wall Projections MantelsVent Termination Minimum Clearances Termination LocationsWood or Fuel Oil Termination Vent Guidelines Vent Information and DiagramsVent System Configuration Wall and Ceiling Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Vertical Penetration FramingAppliance Preparation Gas and Electrical ConnectionsInstall Attic Insulation Shield Installing Vent PipeAssembly of Vent Sections Secure Vent SectionsGas Pressure Gas InformationFuel Conversion Gas ConnectionOptional Accessories Requirements Wiring RequirementsElectrical Information Junction Box Installation Wall Switch Installation for Fan OptionalFinishing Facing MaterialAppliance Setup Glass Assembly Install the Log AssemblyFirescreen Air Shutter Setting Install Louvers and TrimHood Symptom Possible Cause Corrective Action TroubleshootingIntellifire Ignition System Range. Replace pilot if any damage is detected Appliance Dimension Diagram Reference MaterialsService Parts List CB4236IRCB4842IR IPI Valve Assembly Optional Components Model # Description Contact Information

CB4842IR, CB4236IR specifications

Hearth and Home Technologies introduces the CB4842IR and CB4236IR, two premium fireplace options designed to enhance the ambiance and warmth of any space. Both models combine modern technology with elegant design, making them ideal choices for contemporary homes.

The CB4842IR features a large viewing area, measuring 48 inches wide, which provides an impressive visual display of the flames. Its contemporary design allows for a seamless integration into various interior styles, from rustic to minimalist. On the other hand, the CB4236IR, with its 42-inch width, offers a slightly more compact option, perfectly suited for smaller spaces without sacrificing style or warmth.

Both models utilize advanced infrared technology, which provides efficient heat distribution while maintaining a comfortable and inviting atmosphere. This technology ensures that the warmth is evenly radiated throughout the room, creating a cozy environment even in larger areas. Additionally, the infrared heat is effective in penetrating objects and surfaces, resulting in a feeling of warmth that is deeply satisfying.

A standout feature of these fireplaces is the customizable flame settings that allow users to adjust the ambiance to their preference. With multiple flame color options, users can choose from traditional yellow flames to vibrant blue hues, adding a personal touch to the fireplace experience. This feature is particularly useful for setting the mood during different occasions, whether it's a romantic dinner or a lively gathering with friends.

Both the CB4842IR and CB4236IR come equipped with user-friendly controls, enabling easy operation from anywhere in the room. Additionally, they offer programmable thermostats for precise temperature control, further enhancing user convenience and energy efficiency.

Safety features are paramount with Hearth and Home Technologies, and both models include built-in safety mechanisms such as automatic shutoff functions. This ensures peace of mind, whether you're at home or away. Furthermore, the fireplaces are designed for easy maintenance, with features that simplify cleaning and upkeep.

In conclusion, the Hearth and Home Technologies CB4842IR and CB4236IR fireplaces combine aesthetic appeal with advanced heating technology. With customizable flame settings, user-friendly controls, and robust safety features, these models stand out as premium options for anyone looking to enhance their living space with a touch of elegance and warmth. Whether for functionality or style, these fireplaces cater to the needs of modern homeowners, blending seamlessly into any décor.
Top Page Image Contents