Hearth and Home Technologies CB4236IR Maintenance and Service, Maintenance Tasks-Homeowner

Page 12

3 Maintenance and Service

Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.

When properly maintained, your fireplace will give you many years of trouble-free service. We recommend an- nual service by a qualified service technician.

A. Maintenance Tasks-Homeowner

Installation and repair should be done by a qualified service technician only. The fireplace should be inspected before use and at least annually by a professional service person.

The following tasks may be performed annually by the homeowner. If you are uncomfortable performing any of the listed tasks, please call your dealer for a service ap- pointment.

More frequent cleaning may be required due to lint from carpeting or other factors. Control compartment, burner and circulating air passageway of the fireplace must be kept clean.

CAUTION! Risk of Burns! The fireplace should be turned off and cooled before servicing.

Glass Cleaning

Frequency: Seasonally

By: Homeowner

Tools Needed: Protective gloves, glass cleaner, drop cloth and a stable work surface.

Doors, Surrounds, Fronts

Frequency: Annually

By: Homeowner

Tools needed: Protective gloves, stable work surface

•Assess condition of screen and replace as necessary.

•Inspect for scratches, dents or other damage and repair as necessary.

•Check that louvers are not blocked.

•Vacuum and dust surfaces.

Remote Control

Frequency: Seasonally

By: Homeowner

Tools needed: Replacement batteries and remote control in- structions.

•Locate remote control transmitter and receiver.

•Verify operation of remote. Refer to remote control operation instructions for proper calibration and setup procedure.

•Place batteries as needed in remote transmitters and battery-powered receivers.

•Place remote control out of reach of children.

If not using your fireplace for an extended period of time (summer months, vacations/trips, etc), to prevent unin- tended operation:

•Remove batteries from remote controls.

CAUTION! Handle fixed glass assembly with care. Glass is breakable.

•Unplug 3 volt adapter plug on IPI models.

•Avoid striking, scratching or slamming glass

•Avoid abrasive cleaners

•DO NOT clean glass while it is hot

•Prepare a work area large enough to accommodate fixed glass assembly and door frame by placing a drop cloth

on a flat, stable surface.

Note: Fixed glass assembly and gasketing may have residue that can stain carpeting or floor surfaces.

•Remove door or decorative front from fireplace and set aside on work surface.

•See Section 14.J. for instructions to remove fixed glass assembly.

•Clean glass with a non-abrasive commercially available cleaner.

-Light deposits: Use a soft cloth with soap and water

-Heavy deposits: Use commercial fireplace glass cleaner (consult with your dealer)

•Carefully set fixed glass assembly in place on fireplace. Hold glass in place with one hand and secure glass latches with the other hand.

•Reinstall door or decorative front.

Venting

Frequency: Seasonally

By: Homeowner

Tools needed: Protective gloves and safety glasses.

•Inspect venting and termination cap for blockage or obstruction such plants, bird nests, leaves, snow, debris, etc.

•Verify termination cap clearance to subsequent construction (building additions, decks, fences, or sheds). See Section 6.

•Inspect for corrosion or separation.

•Verify weather stripping, sealing and flashing remains intact.

•Inspect draft shield to verify it is not damaged or missing.

12

Heatilator • Caliber BV Series • 4040-262 Rev J • 10/08

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Models CB4236IR CB4842IR Vent Gas Appliance What to do if you smell gasHot glass will cause burns Congratulations Homeowner Reference InformationTable of Contents Installer GuideUser Guide Troubleshooting Warranty Hearth & Home Technologies Limited Warranty CONDITIONS, Exclusions & Limitation of LiabilityWarranty Listing and Code Approvals Gas Fireplace Safety Operating InstructionsYour Fireplace Fixed Glass Assembly Remote Controls, Wall Controls and Wall SwitchesFan Kit optional Clear SpaceFor Your Safety Read Before Lighting Lighting Instructions IPIFrequently Asked Questions After Fireplace is LitMaintenance and Service Maintenance Tasks-HomeownerMaintenance Tasks-Qualified Service Technician Gasket Seal and Glass Assembly InspectionGetting Started Typical Appliance SystemDesign and Installation Considerations Tools and Supplies NeededInspect Appliance and Components Any such action may cause a fire hazardNegative Pressure Framing and Clearances Selecting Appliance LocationConstructing the Appliance Chase Model #Clearances Rough Opening Model Width Height DepthMantel and Wall Projections MantelsTermination Locations Vent Termination Minimum ClearancesWood or Fuel Oil Termination Vent Information and Diagrams Vent GuidelinesVent System Configuration Vent Clearances and Framing Pipe Clearances to CombustiblesWall and Ceiling Penetration Framing Vertical Penetration FramingAppliance Preparation Gas and Electrical ConnectionsInstalling Vent Pipe Assembly of Vent SectionsInstall Attic Insulation Shield Secure Vent SectionsGas Information Fuel ConversionGas Pressure Gas ConnectionWiring Requirements Optional Accessories RequirementsElectrical Information Junction Box Installation Wall Switch Installation for Fan OptionalFinishing Facing MaterialAppliance Setup Install the Log Assembly Glass AssemblyFirescreen Install Louvers and Trim Air Shutter SettingHood Troubleshooting Symptom Possible Cause Corrective ActionIntellifire Ignition System Range. Replace pilot if any damage is detected Appliance Dimension Diagram Reference MaterialsService Parts List CB4236IRCB4842IR IPI Valve Assembly Optional Components Model # Description Contact Information

CB4842IR, CB4236IR specifications

Hearth and Home Technologies introduces the CB4842IR and CB4236IR, two premium fireplace options designed to enhance the ambiance and warmth of any space. Both models combine modern technology with elegant design, making them ideal choices for contemporary homes.

The CB4842IR features a large viewing area, measuring 48 inches wide, which provides an impressive visual display of the flames. Its contemporary design allows for a seamless integration into various interior styles, from rustic to minimalist. On the other hand, the CB4236IR, with its 42-inch width, offers a slightly more compact option, perfectly suited for smaller spaces without sacrificing style or warmth.

Both models utilize advanced infrared technology, which provides efficient heat distribution while maintaining a comfortable and inviting atmosphere. This technology ensures that the warmth is evenly radiated throughout the room, creating a cozy environment even in larger areas. Additionally, the infrared heat is effective in penetrating objects and surfaces, resulting in a feeling of warmth that is deeply satisfying.

A standout feature of these fireplaces is the customizable flame settings that allow users to adjust the ambiance to their preference. With multiple flame color options, users can choose from traditional yellow flames to vibrant blue hues, adding a personal touch to the fireplace experience. This feature is particularly useful for setting the mood during different occasions, whether it's a romantic dinner or a lively gathering with friends.

Both the CB4842IR and CB4236IR come equipped with user-friendly controls, enabling easy operation from anywhere in the room. Additionally, they offer programmable thermostats for precise temperature control, further enhancing user convenience and energy efficiency.

Safety features are paramount with Hearth and Home Technologies, and both models include built-in safety mechanisms such as automatic shutoff functions. This ensures peace of mind, whether you're at home or away. Furthermore, the fireplaces are designed for easy maintenance, with features that simplify cleaning and upkeep.

In conclusion, the Hearth and Home Technologies CB4842IR and CB4236IR fireplaces combine aesthetic appeal with advanced heating technology. With customizable flame settings, user-friendly controls, and robust safety features, these models stand out as premium options for anyone looking to enhance their living space with a touch of elegance and warmth. Whether for functionality or style, these fireplaces cater to the needs of modern homeowners, blending seamlessly into any décor.
Top Page Image Contents