3100-I ACT WOOD INSERT
FAN (BLOWER) INSTALLATION INSTRUCTIONS
Part No.
R
Black & White Wires Attach to Fan Motor Terminals
Speed Control
Screens
(Fan Covers)
Strain Relief Location,
Holding Together Power
Cord and Fan Motor
Wires
Feed Fan Motor
Wires Through Holes
Power Cord
Power cord can be attached to the right or left side.
Included in Kit: (2) Fan mounts & fan assemblies; (1) Speed Control, Power Cord/wire assembly; (1 set) Fan Connector wires, must be high temperature wire; and (1) Strain relief.
Tools Needed: Large Phillips screwdriver, pliers
1.Remove Screens (fan covers).
2.Install fan mounts to outer wall with panel mounting screws.
3.Feed fan and motor wires up through large hole in floor.
NOTE: Power cord can be mounted on left or right side.
4.Connect white and black wires to fan motor terminals and the green ground wire to ground terminal
5.Feed fan motor wires through holes in bottom and across to the other fan motor.
6.Install strain relief onto power cord.
7.Using a pair of pliers, squeeze strain relief and push through hole.
8.Plug in and test blower operation.
9.Replace Screens.
10.Route power cord away from the unit. DO NOT route power under or in front of unit.
FAN SPEED CONTROL ADJUSTMENT, IF
NECESSARY*
*The fan Speed Control for this unit is adjusted at the factory, and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.
1.With the unit plugged in, turn the Speed Control Knob to slow. (Full clockwise.)
2.Use a small screwdriver to adjust the fan speed by turning the adjustment mechanism through the hole on the side of the Speed Control.
3.Adjust the speed so the fan runs slowly but does not stop. Turn clockwise to slow the fan and counter- clockwise to increase the speed.
|
|
|
|
September 1, 2008 | Page 13 | ||