Hearth and Home Technologies 3100-I owner manual ACT Wood Insert, Hot glass will cause burns

Page 1

R

3100-I ACT WOOD INSERT

Advanced Combustion Technology (ACT)

OWNER’S MANUAL

Installation and Operation

Model:

830-0381

Tested and

Beaverton

Listed by

Oregon USA

C US

OMNI- Test Laboratories, Inc.

CAUTION

DO NOT DISCARD THIS MANUAL

Important operating

Read, understand and

Leave this manual with

and maintenance

follow these instructions

party responsible for

instructions included.

for safe installation and

use and operation.

 

operation.

 

DO DIS N C OT AR D

WARNING

If the information in these instructions is not followed exactly, a fire may result causing property damage, personal injury, or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

Do not overfire - If heater or chimney connector glows, you are overfiring. Overfiring will void your warranty.

Comply with all minimum clearances to combustibles as specified. Failure to comply may cause house fire.

Installation and service of this appliance should be performed by qualified personnel. Hearth & Home Technologies recommends NFI certified professionals, or technicians supervised by an NFI certified professional.

WARNING

HOT SURFACES!

Glass and other surfaces are hot during operation AND cool down.

Hot glass will cause burns.

Do not touch glass until it is cooled

NEVER allow children to touch glass

Keep children away

CAREFULLY SUPERVISE children in the same room as appliance

Alert children and adults to hazards of high temperatures

High temperatures may ignite clothing or other flammable materials.

Keep clothing, furniture, draperies and other combustibles away.

WARNING

Fire Risk.

For use with solid wood fuel only. Other fuels may overfire and generate poisonous gases (i.e. carbon monoxide).

www.quadrafire.com

250-6381D

September 1, 2008

Image 1
Contents Hot glass will cause burns ACT Wood InsertACT Wood Insert Sample of Serial Number / Safety LabelTable of Contents Side View Insert Dimensions TOP ViewFront View ACT Wood Insert Clearances to Combustibles Installation Installation recommendationsListings Chimney HEIGHT/DRAFTAlternate Floor Protection Worksheet General Installation ProcedureOvalizing Round Stainless Steel Liners Chimney RequirementsChimney Height Chimney TOP ViewMasonry Fireplace Using DIRECT-CONNECT Method Installation OptionsFactory built zero clearance fireplace Usa installations onlyUse of Leveling Bolts Installation in CanadaSecuring Liner to Chimney Ring Masonry and HEAT-CIRCULATINGDoor Handle Assembly Installation of Panel SET and TrimView of L Bracket Installed Description SizeFAN Speed Control ADJUSTMENT, if Necessary FAN Blower Installation InstructionsSee B Zero Clearance Adjustable Trim SUPPORT, 2 toBuilding a Fire OverfiringWood Selection and Storage Fan operating instructions ACT Wood Insert Operating TipsASH Removal BTU / Hr Start-Up Air Control Primary ControlStory of the Three Burning Stages Air quality and your Quadra-Fire InsertMaintenance Brick Set Part Number Brick replacement instructionsSee C Description Exploded ViewLVR-31-NL Service partsGlass Size 15-1/2 w x 11-3/8 h AccessoriesDate of Service Performed By Description of Service Service And Maintenance LogService And Maintenance Log Cont’d Homeowner’s Notes Hearth & Home Technologies Limited Warranty Warranty PolicyHearth & Home Technologies Limited Warranty Cont’d ACT Wood Insert