GE RAK148P1, RAK164P1 installation instructions Programming, Program Overview, Off position

Page 15

Programming.

Program Overview

The programmable thermostat has four periods (MORN, DAY, EVE, NITE) that are customizable for each day of the week. Each period will have a set time, heat temperature and cool temperature. The thermostat monitors the day and time, while maintaining the specific conditions that you have chosen for each period in your program.

Note: Operation being set will blink in the display.

1.Place the Function switch in the

DAY

Off position.

PROG

2.Press the Hold button in for 6 seconds.

3.Press the Hold button 3 times.

DAY (01–07) and PROG is displayed.

4. Press the < or > button to change the day you want to program (01 = Monday, 02 = Tuesday, etc.).

5.Press the Hold button to advance to the next parameter. Note: You can always press the Mode button to return to the

previous parameter.

•Period is displayed (MORN, DAY, EVE, NITE).

6. Press the < or > button to change period of day. The display should blink the period of the day.

DAY

PROG

MORN

7.Press the Hold button to advance to the next parameter.

• Set time is displayed.

8. Press the < or > button to adjust hours. Press the Hold button once, and then press the

< or > buttons to adjust minutes.

DAY

PROG

AM

MORN

9.Press the Hold button to advance to the next screen parameter. Note: Transitions required after 11:59 PM must be programmed in the next day’s MORN period.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Thermostats Installation InstructionsSpecifications Important safety informationIntroduction Overview Thermostat Control Installation Instructions Use supplied screws to mount thermostat base to wall Turn off power to the heating and cooling systemWiring diagrams Terminals for six wires 2 heat/1 cool system RAK148P1 only Each screen Configuration modeConfiguration Mode Settings Setup screens for Configuration Mode are as followsAdjust to control the maximum Heat set temperature allowed Adjust to control the minimum Cool set temperature allowedOperation Setting the Room Temperature Setpoint TemperatureTesting the thermostat Starting the thermostatAir conditioning should come on within a few seconds Heat Test Heat should come on within a few secondsFan Test Heat Operating functionsOff CoolSetting the time and day of the week Programming Program OverviewOff position Heat temperature is displayed 60F to 85F Repeat ProgrammingPress the button and hold for Seconds. The days of the week Factory preprogramming Low battery warning, Heat mode Low battery indicatorLow battery warning, Off mode Low battery warning, Cool modeCombination failure, Off mode Combination failure, Cool modeCombination failure, Heat mode Problem Solution Troubleshooting tipsPage Page Page For The Period GE Will Replace Thermostat Warranty
Top Page Image Contents