GE RAK164P1, RAK148P1 installation instructions Wiring diagrams

Page 6

INSTALLATION INSTRUCTIONS

TO INSTALL THERMOSTAT (cont.)

14.Replace cover on thermostat by snapping it in place.

15.Turn on power to the system at the main service panel.

16.Test thermostat operation as described in Testing the Thermostat.

Wiring diagrams.

Table 1: Terminals for five wires heat/cool system (RAK164P1 only)

Note: Connect G terminal of thermostat to Zoneline Gl terminal for low fan speed or terminal Gh for high fan speed. Only one can be selected.

6

Image 6

Contents Installation Instructions ThermostatsImportant safety information SpecificationsIntroduction Overview Thermostat Control Installation Instructions Turn off power to the heating and cooling system Use supplied screws to mount thermostat base to wallWiring diagrams Terminals for six wires 2 heat/1 cool system RAK148P1 only Setup screens for Configuration Mode are as follows Configuration modeConfiguration Mode Settings Each screenAdjust to control the minimum Cool set temperature allowed Adjust to control the maximum Heat set temperature allowedSetting the Room Temperature Setpoint Temperature OperationTesting the thermostat Starting the thermostatAir conditioning should come on within a few seconds Heat Test Heat should come on within a few secondsFan Test Cool Operating functionsOff HeatSetting the time and day of the week Programming Program OverviewOff position Heat temperature is displayed 60F to 85F Repeat ProgrammingPress the button and hold for Seconds. The days of the week Factory preprogramming Low battery warning, Cool mode Low battery indicatorLow battery warning, Off mode Low battery warning, Heat modeCombination failure, Off mode Combination failure, Cool modeCombination failure, Heat mode Troubleshooting tips Problem SolutionPage Page Page Thermostat Warranty For The Period GE Will Replace