GE RAK164P1, RAK148P1 Heat temperature is displayed 60F to 85F, Repeat Programming

Page 16

Programming.

•Heat temperature is displayed (60°F to 85°F)

10.Press the < or > button to adjust heat set temperature.

DAY

PROG

AM

HEAT

MORN

11.Press the Hold button to advance to the next screen.

•Cool temperature is displayed (60°F to 85°F)

12.Press the < or > button to adjust cool set temperature.

DAY COOL

PROG

AM

MORN

13.Press the Hold button to advance to the next screen.

Repeat steps 1–13 to program each day of the week individually or follow the instructions below to program every day the same as Monday. When programming is complete, slide the Function switch to Heat or Cool to exit Programming Mode.

Repeat Programming

Once the entire Monday (Day 01) schedule is set, the following procedure can be used to copy the Monday schedule for every day of the week.

After the complete Monday schedule is set (see Programming, above), you will be at the “Day” screen:

1. Press the < button once. Day

01 screen displays.

DAY

PROG

2. Press the < button and hold for

2 seconds. The days of the week

stop flashing, locking the settings into memory. Once the schedule is locked in, you can go through each day and make any required changes. This feature speeds up the programming of the standard weekday/weekend schedule.

3. Slide the Function switch to Heat or Cool to exit Programming Mode.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Installation Instructions ThermostatsImportant safety information SpecificationsIntroduction Overview Thermostat Control Installation Instructions Turn off power to the heating and cooling system Use supplied screws to mount thermostat base to wallWiring diagrams Terminals for six wires 2 heat/1 cool system RAK148P1 only Configuration mode Configuration Mode SettingsSetup screens for Configuration Mode are as follows Each screenAdjust to control the minimum Cool set temperature allowed Adjust to control the maximum Heat set temperature allowedSetting the Room Temperature Setpoint Temperature OperationStarting the thermostat Testing the thermostatAir conditioning should come on within a few seconds Heat should come on within a few seconds Heat TestFan Test Operating functions OffCool HeatSetting the time and day of the week Program Overview ProgrammingOff position Repeat Programming Heat temperature is displayed 60F to 85FPress the button and hold for Seconds. The days of the week Factory preprogramming Low battery indicator Low battery warning, Off modeLow battery warning, Cool mode Low battery warning, Heat modeCombination failure, Cool mode Combination failure, Off modeCombination failure, Heat mode Troubleshooting tips Problem SolutionPage Page Page Thermostat Warranty For The Period GE Will Replace
Top Page Image Contents