Using Your Air Conditioner to Dehumidify
If Cool to Dehumidify is on and the Humidity Module is installed, the thermostat has the ability to initiate a cooling cycle for advanced dehumidification operation. When the thermostat detects the humidity percentage is above the setpoint for dehumidification, and heating or cooling is not on, the thermostat will force the compressor to run with the fan, thus reducing moisture in the air. The green LED will blink once every eight seconds to indicate this is taking place. This feature will also allow you to adjust the cooling overshoot of the setpoint, from 0° to 5° (adjustable in step #9). For Example: If the cooling overshoot is set for 3°F and the cooling setpoint is set for 74°F, then as long as the room temperature reads between 71°F and 74°F this feature will energize the compressor and fan to dehumidify the air.
MODE
HUMIDITY
MODE
Press the MODE button. While holding the MODE, press the HUMIDITY button to enter Setup screens.
Press the MODE button repeatedly until this setup screen appears.
Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE button to move back- wards through the setup screens.
9
Steps 8 and 9 only appear if the Dehumidification |
| ||
setpoint is not 99% (see page 9.3). |
| 8 | |
On | Setup | ||
| |||
|
| ||
| DeHumidify |
| |
Select Cool to |
|
| |
Dehumidify feature. | OFF |
| |
Off |
|
| |
Step 9 appears only if step 8 is set to “ON” | 9 | ||
Adjust the maximum | 3 | ||
DeHumidify Setup | |||
overshoot of the set |
| COOL | |
temperature in Cool to |
|
| |
Dehumidify mode. |
|
| |
(0 - 5 ) |
|
|
Press the HUMIDITY button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.
Press
MODE
Press
HUMIDITY
Dehumidification Notes: The thermostat must be in the Cool or Auto mode for the Cool to Dehumidify feature to be available.
Page 9.4