American Standard T506.740 instruction

Installation

Instructions

MOMENTST506.740

CENTRAL THERMOSTAT

WITH VOLUME CONTROL

TRIM KIT

Thank you for selecting American-Standard...the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin. Certiﬁed to comply with ANSI A112.18.1M

ASSE 1016

M 9 6 8 0 2 6

ROUGHING-IN DIMENSIONS

220mm

(8-5/8)

R520

1/2" NPT INLETS

R540

3/4" NPT INLETS

170mm

(6-3/4)

186mm

(7-3/8)

	NOTE: FITTING	25mm
	NOTE: FITTING	(1)
	MUST BE INSTALLED	(1)
	MUST BE INSTALLED
	WITH VOLUME CONTROL
	ON TOP.

160mm

(6-1/4)

FINISHED

WALL

100mm

(3-7/8)

48mm to 68mm

(2 to 2-5/8)

Recommended Tools

Flat Blade Screwdriver

Phillips Screwdriver

CARE INSTRUCTIONS:

To keep your new faucet looking new, please follow these simple care instructions:

DO: Simply rinse the faucet clean with clear water. Dry the faucet with a soft cotton cloth.

DO NOT:

Do not use any abrasive cleaners, cloths, or paper towels.

Do not use any cleaning agents containing acids, polish abrasives, or harsh cleaners or soaps.

Regular and routine cleaning will reduce the need for heavy cleaning and polishing. If heavy cleaning is required, the following procedures are recommended:

Remove as much surface dirt and ﬁlm using clear water and soft cotton cloth (as described above).

Use any of the following to remove tough surface ﬁlm and build-up:

Mild liquid detergents

Clear ammonia free liquid glass cleaners Non-acidic, non-abrasive gentle liquid or fully dissolved powder cleansers mixed according to manufacturers directions.

Non-abrasive liquid polishers

Once clean, rinse faucet again with clear water to thoroughly remove cleaner or polish and blot dry with a soft cotton cloth.

Failure to follow these care instructions may damage the Faucet's ﬁnish.