|
| Troubleshooting |
|
|
|
Problem | Cause | Solution |
|
|
|
|
|
|
Unit pumps but output flow is | Clogged inlet suction screen | Clean or replace. |
low. | (used oil). |
|
|
|
|
| Air leak in suction tube. | Check to make sure all joints in |
|
| suction tube are sealed. |
|
|
|
| Suction tube too close to tank | Suction tube must have a 2 in. |
| bottom. | (51 mm) minimum clearance. |
|
|
|
| Tank empty. | Refill tank. |
|
|
|
| Tank not vented. | Tank must be vented to atmo- |
|
| sphere. |
|
|
|
| Worn or damaged gears. | Remove cover and inspect |
|
| gears. Replace if worn or dam- |
|
| aged. |
|
|
|
| Damaged motor. | Replace motor. |
|
|
|
| Clogged suction tube, hose, or | Inspect and clean. |
| nozzle. |
|
|
|
|
Motor stalls when nozzle is | Bypass relief valve is stuck. | Inspect relief valve, making |
closed. |
| sure ball is free. Replace if |
|
| damaged. |
|
|
|
| Low supply voltage. | Check supply voltage. |
|
|
|
| Gears damaged and binding. | Inspect gears. Gears should |
|
| turn freely. Replace if dam- |
|
| aged. |
|
|
|
| Faulty motor. | Replace motor. |
|
|
|
Motor overheating. | Gears binding. | Check to make sure gears turn |
|
| freely on shaft. |
|
|
|
| Operating pump extended time | Do not exceed 5 minutes of |
| with nozzle closed. | operation with nozzle closed. |
|
|
|
| Clogged inlet suction screen. | Clean or replace. |
|
|
|
| Clogged suction tube, hose, or | Inspect and clean if required. |
| nozzle. |
|
|
|
|
| Operating pump more than 30 | Limit operation to 30 minutes |
| minutes continuous duty. | per hour. |
|
|
|
Switch will not turn pump on. | Blown fuse or circuit breaker. | Check electrical supply. |
|
|
|
| Electrical problem. | Check that supply voltage is |
|
| proper and getting to pump. |
|
|
|
| Defective switch. | Check and replace motor (9) if |
|
| defective. |
|
|
|
| Damaged or defective motor. | Check motor, replace if dam- |
|
| aged or defective. |
|
|
|
311305E | 7 |