State Industries SRT80 120NE warranty Menu Tree

Menu Tree

Main Menu	Description
Temperatures
Outlet	Displays the temperature of the outlet tank probe.
Tank	Displays the temperature of the probe located in the tank.
System Status
LWCO	Low Water Cut-Off status. The status can be either Closed or Open. A Closed status indicates that there is not
	a low water condition in the tank. An Open status indicates that there is a low water condition in the tank.
ECO	Emergency Cut-Off status. The status can be either Closed or Open. A Closed status indicates safe operation.
	An Open status indicates that the system is locked out due to the water temperature reaching an unsafe
	temperature value.
BlwPrv	Blower prover status. The status can be either Closed or Open. A Closed status indicates that combustion air
	is adequate. An Open status indicates that combustion air is inadequate.
Blk Out	Blocked outlet status. The status can be either Closed or Open. A Closed status indicates normal operation.
	An Open status indicates that the exhaust outlet is blocked.
Low Gas	Low gas status. The status can be either Closed or Open. A Closed status indicates normal operation. An
	Open status indicates low supply gas pressure.
Freeze State	(Anti-Freeze kit only)
	This indicates the status of the freeze condition aquastat. The status can either be OK or Freeze. An OK
	status indicates normal operation. A Freeze condition indicates that freezing conditions exist and the system
	is responding.
Tank Drain	(Anti-Freeze kit only)
	Tank drain status. This status can either be Closed or Open. A Closed status indicates that the system is in
	normal operation and the tank drain valve is closed. An Open status indicates that the system is draining the
	tank to deter freezing.
Tank Pump	Status of the tank pump. This indicates if the tank pump is enabled by the control. The status is either On or
	Off. An On status indicates the control is asking for the tank pump to be turned on. An Off status indicates that
	the control is asking for the tank pump to be turned off.
Loop Pumps	Status of the loop pumps. This indicates if the loop pumps are enabled by the control. The status is either
	Enabled or Disabled. An Enabled status indicates the control is asking for the loop pumps to be turned on.
User Settings	A Disabled status indicates that the control is asking for the loop pumps to be turned off.
Setpoint	The setpoint is the temperature to which water will be heated and stored. Allowable range is 100°F to 180°F.
Diff	Temperature difference below the operating set point before the system will call for heat. Allowable range of
	0°F to 50°F.
Temp Units	Temperature unit of the system for display. This can either be °F or °C.
Netwrt Addr	(PC Networking only)
	Network address of the heater on State Industries Networking network. This number must be unique to all
	devices on the network. Allowable range of 1 to 32 on the network, or 0 to place the device off the network.
Log Info
Run Min	The total number of minutes of heating.
Cycles	The total number of cycles the heater achieved. A cycle is defined as a transition from an idle state to a heat
	state.
kBTU	(for reference only)
	This is a factory setting for reference only.
Prop Rev	This will display the current software revision.
Current Error	The current error screen displays the current error, if the system is in an error state.
Error History	The error history screen will display the previous nine recorded errors by the system along with the running
	minutes of when the error occurred.
Reload Defaults	Allows for re-setting the system to its factory defaults.

20