White W2500 manual Edges, Turning Curved, Removing Stitches, From Sewn Fabric

BASIC TECHNIQUES
TURNING OUTSIDE		CORNERS
WITHOUT CUTTING		THREADS
1.	When you reach the fabric	edge, stop stitching with the
	needle above the fabric.
2.	Raise the presser foot and gently pull		on the thread chain
	just enough to clear the stitch finger.
3.	Turn the fabric, lower the presser foot		and begin stitching
	in the new direction. Fig. 1.
NOTE: When overlocking and		trimming	at the same time,
	cut the fabric along the new stitching line for about
	3 cm, before turning the fabric. Fig. 2.

Fig.	1
*1
Fl g.	2

TURNING				CURVED		EDGES
For	inside	curves, guide fabric gently with trimming						line of
the	fabric under the				right front of		the presser foot (or	a little
to the left),		applying			pressure at		point A in the direction of
the	arrow with your left hand,					and	at the same time applying
a little opposite pressure at						point B with your right		hand.
Fig.	3.
For outside curves place under the presser foot in a similar
manner but applying					the pressure		in the opposite directions.
Fig.	4.
REMOVING STITCHES							FROM SEWN
FABRIC
To remove		stitches already sewn,					snip off needle thread(s)
at intervals		and		pull out looper thread(s).
Illustration		*	I	: Cut

A

Fig. 3 Fig. 4