White W2500 Helpful Hints, Replacing Thread Spools, Cutting Needle Thread, Raise presser foot

HELPFUL HINTS

REPLACING THREAD SPOOLS

When replacing thread spools, the following steps may be helpful for quick changeover.

1.Cut off existing threads near the spools. Tie the cut ends thread from new spools as illustrated (seamen’s knot).

2.Raise presser foot.

3.Lower needle bar to its lowest position by turning hand wheel AWAY FROM YOU. Carefully pull the existing threads until the connecting knots pass through needle eye and looper eyes.

CUTTING NEEDLE THREAD

Frayed thread may make needle threading difficult.

Draw the thread near the thread cutter on the needle plate and push the thread cutter lever or draw the thread passing under the moving cutter and turn hand wheel towards you to obtain clear cut end as illustrated.