Bernina V29.39.00 manual Embroidery Updates Bernina 830 only, Start of embroidery

Page 10

3 Embroidery Updates (BERNINA 830 only)

3.1 Start of embroidery

If the Start button was pressed while the bobbin door was open, either the embroidery start was not possible or the start position was incorrect. This has been resolved.

3.2 Using zoom option with panning

When using the zoom option, only the view of the design will be moved. The hoop position rela- tive to the design will not be changed.

3.3Using Foot #44C (The new CutWork & Echo quilting foot)

Developed for the CutWork tool, this foot can also be used for quilting.

For designs with “cut” and “normal” embroidery layers, the foot #44C can be selected in the stitch out mode. The outlines for the selected foot will be immediately set. The position of the design will not change.

10/14, 04.11.2009

Image 10

Contents Bernina Software Version General Changes Sewing UpdatesEmbroidery Updates Bernina 830 only Important pointsLanguage Finnish integrated Software VersionGeneral Changes Display of data version numberThread tension for the underlay segments buttonholes Sewing UpdatesManual threading Thread cutting without fabric movement Use of straight stitch feet with thread cuttingManual winding of the lower bobbin thread Winding indicator during sewing/embroidery Reset of back stepping historyProblem with Foot #57D and straight stitch compatibility Thread breakage hintInformation Foot #2a corrected Tension changed for the tie on stitches Pattern #169 improvedUpper thread detection changed Using Foot #44C The new CutWork & Echo quilting foot Embroidery Updates Bernina 830 onlyUsing zoom option with panning Start of embroideryThread tension can be changed to a minimum Stop for manual cutting can be switched off Manual tie on for embroideryImportant points Stitching without thread, is displayed in embroidery modeFeedback issues Hoop calibration