Information on Software Update
BERNINA 830 / 820
Software Version | 3 | ||||
1 General Changes | 3 | ||||
| 1.1 Language “Finnish” integrated | 3 | |||
| 1.2 | Display of data version number | 3 | ||
2 Sewing Updates | 4 | ||||
| 2.1 Thread tension for the underlay segments (buttonholes) | 4 | |||
| 2.2 | Manual threading | 5 | ||
| 2.3 | The use of straight stitch feet with thread cutting | 5 | ||
| 2.4 | Disable automatic thread cutting when opening the bobbin door | 5 | ||
| 2.5 | Thread cutting without fabric movement | 5 | ||
2.6 | “Manual” winding of the lower bobbin thread | 5 | |||
| 2.7 Winding indicator during sewing/embroidery | 6 | |||
2.8 | Reset of back stepping history | 6 | |||
|
|
|
|
| |
2.9 | Thread breakage hint | 7 | |||
|
| 2.10 Problem with Foot #57D and straight stitch plate compatibility | 7 | ||
|
| 2.11 Presser Foot #0 can be used for automatic threading. With the “Walking foot” |
| ||
|
|
|
| automatic threading is not possible | 8 |
|
| 2.12 Information Foot #2a corrected | 8 | ||
|
| 2.13 Pattern #169 improved | 9 | ||
|
| 2.14 Tension changed for the “tie on” stitches | 9 | ||
|
| 2.15 Upper thread detection changed | 9 | ||
3 Embroidery Updates (BERNINA 830 only) | 10 | ||||
|
| 3.1 Start of embroidery | 10 | ||
|
| 3.2 Using zoom option with panning | 10 | ||
3.3 | Using Foot #44C (The new CutWork & Echo quilting foot) | 10 | |||
|
|
|
| ||
3.4 | Thread tension can be changed to a minimum of 0.5 | 11 | |||
|
|
|
| ||
3.5 | Stop for manual cutting can be switched off | 12 | |||
|
|
|
| ||
3.6 | Manual “tie on” for embroidery | 12 | |||
|
|
|
| ||
3.7 | Delay of Start/Stop button reduced for embroidery | 13 | |||
|
| 3.8 Thread breakage during jump stitches | 13 | ||
3.9 | Stitching “without thread”, shown now in embroidery mode | 13 | |||
|
|
| |||
4 Important points | 13 | ||||
|
| 4.1 Hoop calibration | 13 | ||
|
| 4.2 Feedback issues | 13 | ||
|
| 4.3 Free memory | 13 | ||
2/14, 04.11.2009