3D Connexion 7318 instruction manual Button Sewing

q

r

w	Button Sewing
e	Machine setting
	q Stitch pattern:	C
t	w Stitch width:	Adjust as necessary
	e Stitch length:	Any
	r Thread tension: 3 – 7
	t Presser foot:	Zigzag foot A
	y Feed dog:	Lowered

y

Unthread the needle. Adjust the stitch width to match it with the span of the holes in the button. Turn the handwheel to check if the needle enters into each hole in the button.

Lower the foot to hold the button in place.

The holes in the button should align with the slot of the foot.

	A pin can be placed on the foot to form a shank.
	Make sure to check if the needle enters into both
	holes in the button.
	q Pin
	Re-thread the needle and sew about 10 stitches
	and cut the needle and bobbin threads at the
q	beginning.
	Raise the presser foot and remove the fabric. Cut
w	the needle and bobbin threads leaving 8˝ (20 cm)
	tails.
	Bring the needle thread between the button and
	fabric through the holes in the button.
	Pull the needle thread to pick bobbin thread up to
	the right side of the fabric.
e	Wind the threads to from a shank and tie them
	together.
	w Needle thread
	e Bobbin thread
	NOTE:
	Raise the feed dog after sewing.

21