England's Stove Works PELLET STOVES operation manual Call Technical Support at 800, Control Board

Page 17

Control Board

Control Board

The Control Board (Part #PU-CB04) is a digital read-out board. This board offers a wide variety of settings to operate the unit. This part can be removed from the unit by loosening the two outside screws and pulling the board back to the inside of the stove. The rear access panel should be removed prior to removing the control board. A 6-amp “quick-blow” fuse is used on this Control Board.

NOTE: The bottom three control buttons are preset at the factory and should not require any changes. See “Operating Instructions” and “Daily Operation” section of the manual for instructions on other Control Board settings.

	Recommended Heat Ranges:
Low Burn:	Heat Range setting:	1		Room Air Blower setting:	1
Medium Low:	Heat Range setting: 2		– 3	Room Air Blower setting: *
Medium High:	Heat Range setting:	5	– 8	Room Air Blower setting: *
High Burn:	Heat Range setting:	9		Room Air Blower setting:	9

* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.

CAUTION:

NOTE: The bottom

3buttons are pre-set at the factory and do not need adjustment.

Call Service at

(800) 245-6489 if you have questions or problems.

Illustration 3

Control Board

Diagram

Caution

Should you see any evidence of smoke in the hopper (smoke back), immediately close and latch the hopper lid and door to the unit. Open the nearest windows and door to the outside, then press the OFF button and let the unit cool for at least 3 hours. Do not open the door or hopper lid. This is a maintenance problem that needs to be addressed.

Call Technical Support at (800) 245-6489.

17

Image 17

Contents SAFETY NOTICE INSTALLATION & OPERATION MANUALPlease Note the Following Precautionary Statements Save These InstructionsWishing you years of efficient, quality and “comfy” heating A letter from our Technical Support departmentThank you for purchasing this fine product from England’s Stove Works A NOTE ON COLD AIR RETURNS AND CENTRAL FURNACES BEFORE RE-STARTING YOUR UNITIN THE EVENT OF SMOKE-BACK Please call Technical Support at 800 245-6489 with any questionsIMPORTANT INFORMATION UNIT PREPARATION Proper Impingement Baffle Plate Placement in Pellet Stove Firebox FLUE SYSTEM NOTE See the installation drawing later in this manual IllustrationBe sure to check local codes in your area Pellet Vent PipeImportant Notes Concerning Installation Mobile Home InstallationThrough the Ceiling Existing Flue SystemFLOOR AND WALL PROTECTION Freestanding Pellet InstallationFloor Protection Wall ProtectionOPERATING INSTRUCTIONS START- UP PROCEDUREHorizontal Feed System Automatic Start-Upuntil the room air blower begins to operate SHUT-DOWN PROCEDUREE-Codes Unit’s State Before Power Loss Power OutageState When Power Returns Refueling the UnitSemi-Weekly Ash Removal Daily Ash MaintenanceASH REMOVAL AND DISPOSAL Monthly Ash Removal Annual CleaningCAUTION UNPLUG THE UNIT PRIOR TO ANY SERVICE WORK MAINTENANCERear Panel Removal Auger MotorsConvection Blower Vacuum SwitchCombustion Blower GasketsControl Board Call Technical Support at 800CAUTION Moving Parts May Cause Injury Do NOT Operate with Panels Off Disconnect Power Before Servicing UnitDANGER Parts May Be Hot. Risk of Electric Shock Illustration 4 PU-CB04 Control Board Diagram WiringIllustration Hopper Lid Latch Adjusting your Hopper Lid LatchesThermostats ACCESSORY ITEMSAC-103, AC-103BN Lip Trim AC-106-P SH-106-P, AC-106-PBN Window TrimOPTIONS service@englanderstoves.comTechnical Support Department P.O. BoxDimensions of your pellet unit Pellet Stove - Exploded View Diagram28 ½”W x 30”H x 28 ½”D 375 lbsProblem TROUBLE-SHOOTING GUIDESolution CauseFROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER LIMITED 5 YEAR WARRANTYProcedure The manufacturer extends the following warrantiesUNIT INFORMATION WARRANTY REGISTRATION for England’s Stove WorksDEALER INFORMATION