England's Stove Works PELLET STOVES Accessory Items, Thermostats, AC-103, AC-103BN Lip Trim

Page 20
ACCESSORY ITEMS

ACCESSORY ITEMS

The following accessories can be added to your unit at anytime after purchase; however, let the unit cool down before adding any accessories.

Thermostats

WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on our pellet units as long as it is a low-voltage that works with millivolt systems. After unplugging the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two screws should then be loosened and the jumper wire removed from the board. Next, the two thermostat lead wires should be slipped into these openings and the screws tightened; the jumper wire should be saved for future operation without a thermostat.

The unit will operate differently once the wall thermostat is connected – we recommend the Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.

AC-103, AC-103BN Lip Trim

There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the stove. Match the channel with the correct edge of the ash apron, then remove the protective covering from the trim and force the piece onto the edge. Although it should stay in place, stove cement can be used to secure it if necessary.

NOTE: For stoves manufactured prior to 2001, the part number for this kit is AC-101-PU.

AC-106-P (SH-106-P), AC-106-PBN Window Trim

Window trim can be attached by using the provided spring clip(s) and some high temperature silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then, turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it is placed on the top edge of the trim before placing the trim in the window of the stove. Place the top edge with the clip into the window opening, then push the bottom edge of the trim flush with the window. We also suggest that high temperature silicone be used on the corners, to ensure the trim will stay in place.

Accessories can be ordered from the factory at:

(Parts orders ONLY) -- (800) 516-3636, or on our web site: www.englanderstoves.com.

Questions/Problems: Please call Technical Support at (800) 245-6489.

You may also order parts and options, view frequently asked questions and more,

on our web site: www.englanderstoves.com

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents INSTALLATION & OPERATION MANUAL SAFETY NOTICEPlease Note the Following Precautionary Statements Save These InstructionsWishing you years of efficient, quality and “comfy” heating A letter from our Technical Support departmentThank you for purchasing this fine product from England’s Stove Works BEFORE RE-STARTING YOUR UNIT A NOTE ON COLD AIR RETURNS AND CENTRAL FURNACESIN THE EVENT OF SMOKE-BACK Please call Technical Support at 800 245-6489 with any questionsIMPORTANT INFORMATION UNIT PREPARATION Proper Impingement Baffle Plate Placement in Pellet Stove Firebox NOTE See the installation drawing later in this manual Illustration FLUE SYSTEMBe sure to check local codes in your area Pellet Vent PipeMobile Home Installation Important Notes Concerning InstallationThrough the Ceiling Existing Flue SystemFreestanding Pellet Installation FLOOR AND WALL PROTECTIONFloor Protection Wall ProtectionSTART- UP PROCEDURE OPERATING INSTRUCTIONSHorizontal Feed System Automatic Start-Upuntil the room air blower begins to operate SHUT-DOWN PROCEDUREE-Codes Power Outage Unit’s State Before Power LossState When Power Returns Refueling the UnitSemi-Weekly Ash Removal Daily Ash MaintenanceASH REMOVAL AND DISPOSAL Annual Cleaning Monthly Ash RemovalMAINTENANCE CAUTION UNPLUG THE UNIT PRIOR TO ANY SERVICE WORKRear Panel Removal Auger MotorsVacuum Switch Convection BlowerCombustion Blower GasketsCall Technical Support at 800 Control BoardDisconnect Power Before Servicing Unit CAUTION Moving Parts May Cause Injury Do NOT Operate with Panels OffDANGER Parts May Be Hot. Risk of Electric Shock Illustration 4 PU-CB04 Control Board Diagram WiringAdjusting your Hopper Lid Latches Illustration Hopper Lid LatchACCESSORY ITEMS ThermostatsAC-103, AC-103BN Lip Trim AC-106-P SH-106-P, AC-106-PBN Window Trimservice@englanderstoves.com OPTIONSTechnical Support Department P.O. BoxPellet Stove - Exploded View Diagram Dimensions of your pellet unit28 ½”W x 30”H x 28 ½”D 375 lbsTROUBLE-SHOOTING GUIDE ProblemSolution CauseLIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNERProcedure The manufacturer extends the following warrantiesUNIT INFORMATION WARRANTY REGISTRATION for England’s Stove WorksDEALER INFORMATION
Top Page Image Contents