Drolet 75281 owner manual Tips on Wood Heating

Page 5

TIPS ON WOOD HEATING

Wood is a renewable energy. It is also a very clean heat source when used with appliances that are certified by the U.S. Environmental Protection Agency (EPA), a standard accepted in Canada as well.

EPA-certified wood stoves are different than conventional wood stoves. Burning with an EPA-certified wood stove may therefore require that you modify some of your heating habits. To get the most satisfaction out of your new wood-heating system, please make sure you go through the following check list.

9The chimney is the engine that drives the wood-heating system. Use a chimney that is UL-listed, with an inner diameter to match the stove’s outlet collar (6” for all Drolet wood stoves);

9Try to run the chimney inside the building for as much length as you can. A tall and warm chimney will produce a good draft;

9Try to install your chimney straight up and avoid 90 degree turns in the flue pipe and offsets in the chimney;

9Make sure that the chimney is tall enough and its top is clear of obstacles so it can produce a stable draft;

9Use a chimney thermometer installed at a distance of approximately 18 inches on the flue pipe above the stove. Flue gases should reach at least 350oF before you close the stove’s primary air intake completely. Operate your unit within the comfort zone indicated on the thermometer;

9To reduce the risk of smoke spillage into the room upon reloading your stove, leave the primary air intake completely open for a few minutes. This will heat up the chimney and build up draft before you open the stove door;

9Maximize hot air circulation! Our wood stoves are designed to easily receive a variable speed blower that will improve heat distribution in front of the stove;

9Remember that wood stoves produce radiant heat. Since heat rises, the use of floor traps will greatly improve the heat transfer to rooms upstairs;

9Use a mobile home approved stove if you are going to install your wood-heating system in a mobile home. A fresh air kit must be connected to the stove. Never install your wood stove in a bedroom;

9Burn only dry cordwood;

9Make sure you have a good bed of red coals before you load your stove with logs exceeding 3 inches in diameter;

9Read and keep you owner’s manual. It will provide you with tips on how to run a successful wood-heating system.

4

Image 5
Contents Read and Keep this Manual for Reference OWNER`S Manual Drolet EPA WoodstovesTable of Contents Introduction Overall Technical SpecificationsTips on Wood Heating Pedestal and Decorative Sidewall Installation AssemblyHT-1600 Refractory Bricks Assembly Bricks and Insulation Installation HT-1600HT-2000 Refractory Bricks Assembly Brick and Insulation Installation HT-2000Air Tubes Installation AIR Tubes Installation HT-2000Door Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Canada ClearancesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsClay liner Factory Built Thimble Brick Thimble Average Energy Yield Of One Air Dried Cord Of Cut Wood Woodstove UtilizationIgnition Testing Your WoodFirst Fires Heating Creosote Formation and Need for Removal ReloadingASH Disposal Glass MaintenanceGasketing PaintDrolet Limited Lifetime Warranty