INSTALLATION
Venting Introduction
This pellet stove operates on a negative draft system, which pulls combustion air through the burn pot and pushes the exhaust air to the vent pipe and out of the building. This unit must be installed in accordance with the following detailed descriptions of venting techniques; not installing the stove in accordance with the details listed here can result in poor stove performance, property damage, bodily injury or death. England’s Stove Works is not responsible for any damage incurred due to a poor or unsafe installation.
If questions arise pertaining to the safe installation of the stove, our customer service line
Venting Guidelines
•ALWAYS install vent pipe in strict adherence with the instructions and clearances included with your venting system.
•DO NOT connect this pellet stove to a chimney flue which also serves another appliance.
•DO NOT install a flue pipe damper or any other restrictive device in the exhaust venting system of this unit.
•ONLY use chimney liners listed for pellet appliance venting; do not use galvanized or
•INSTALL a
•SEAL each joint of pellet vent with high temperature silicone (Part # AC- RTV3) to prevent smoke spillage into the home.
•AVOID excessive horizontal runs and elbows, as both will reduce the draft of the venting system and will result in poor stove performance.
•INCLUDE as much vertical pipe as possible to prevent smoke from the unit from entering your home in the event of a power outage.
•INSPECT your venting system often to be certain it is clear of
•CLEAN your venting system as detailed in the maintenance section of this manual.
WARNING: Venting system surfaces get HOT, and can cause burns if
touched. Noncombustible shielding or guards may be required.
Page 10