England's Stove Works 25-EPI operation manual Installation

INSTALLATION

Insert Assembly Continued

6.Use the included self-drilling sheet metal screws to screw the Rear Hopper Cover Plate to the hopper of the stove while carefully holding the lid in place to be certain in remains centered on the stove. A set of clamps or an extra set of hands is very useful at this point of the conversion, but not required.

7.Using a 5/16” socket or open end wrench, remove one of the hopper lid latches from the original hopper lid. Install this hopper lid latch on the new hopper lid and check to be certain the hopper lid is closing tightly. If not, adjust the latch until a proper seal is made.

8.Next, install the insert side panels; these panels install much the same way as the original side panels. Do not screw the side panels to the stove using the rear screws at this time.

9.Install the surround side panels, one side at a time, and install the two self- tapping sheet metal screws into the pre-drilled holes in the stove body. These screws should pass through the surround side panel, the insert side

panel and then into the stove body.

10.Next, slide the top surround panel onto the pre-installed sheet metal screws on the top of the Rear Hopper Cover Plate. Install two ¼” bolts through the pre-drilled holes on either side of the surround top panel where it meets the two side panels of the surround.

11.Tighten the 1/4” bolts first, and then, using a 5/16” socket or open end wrench, tighten the sheet metal screws on the top of the Rear Hopper Cover Plate.

12.Using a 5/16” socket or open end wrench, remove the two sheet metal screws which hold the control panel mounting box to the stove body. The wires which connect the control board to the stove components have been intentionally long, so that the control board can simply be remounted to the right surround panel without any additional wiring.

13.Loosen the four bolts that secure the pedestal to the unit. These bolts are located on the underside of the unit and can be loosened and removed using a ½” socket on a socket wrench. ONCE THESE BOLTS ARE

LOOSENED AND REMOVED, THE UNIT IS FREE FROM THE PEDESTAL AND CAN FALL, CAUSING INJURY. BE CAREFUL WHEN REMOVING THESE BOLTS AND HAVE A HELPER WHEN LIFTING THE STOVE FROM THE PEDESTAL.

Page 8