Enviro C-10608 owner manual Fresh Air Intake

Page 17

Installation

MOBILE HOME INSTALLATION:

●Secure the heater to the floor using the two holes in the pedestal.

●Ensure the unit is electrically grounded to the chassis of your home (permanently).

●Do not install in a room people sleep in.

●Outside fresh air is mandatory. Secure outside air connections directly to fresh air intake pipe and secure with three

(3) screws evenly spaced.

CAUTION: THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINED.

ENVIRO EF5

Optional

Hearth Pad

Flooring

Steel Frame

1/4” Lag Bolts	Ground Wire Directly
Securely Fastened	to Metal Chassis

Figure 12: Mobile home installation.

CORNER THROUGH WALL INSTALLATION:

Fresh Air Intake

3" (7.5 cm)

Wall thimble

manufactured

by pellet vent

manufacturer.

3"

(7.5 cm)

Figure 13: Corner Installation.

17

Image 17

Contents

Evolution Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionI. Pellet Standards USE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Operating Instructions Reasons WHY the Unit OverheatedInitial START-UP See above Thermostat / Switch ModeTools Required to Clean Unit Routine Cleaning and MaintenanceBurner POT and Liner 2-3 days Heat Exchanger Tubes 2-3 daysASH PAN weekly Door Glass Cleaning 2-3 daysFresh AIR Intake biannually Exhaust Passages biannuallyCleaning Plated Surfaces Post Season CLEAN-UPDoor Glass Replacement Brick PanelScrews to take out to remove stove from pallet InstallationDimensions of EF5 Minimum Alcove depth Inches Installing Hearth Pad Pedestal onto EF5 Crawlspace, narrow Walkway Closely Exhaust Fresh Air Intake Page Venting horizontally with rise Inside Vertical Installation Outside Vertical Installation Exterior Blower Kit Through vent holeThrough Wall Installation with Exterior Blower Kit EF5 REQUIRED, please follow the instructions below If you wish to adjust the slider damper externally notSpecial Notes Slider Damper Located Behind Left Side panel. To openStove will not operate when hot TroubleshootingDo not What to do ifLight # 2 on Heat output bar flashing 200 F 93 C high limit temperature sensor has trippedExhaust motor will not function normally Convection blower will not function normally Control settings Heat Level has no effect on the fireIgnitor- the pellets will not light Stove keeps going out5V DC Wiring DiagramReference Number Description Part Number Parts List50-1085 Parts Diagram Components SteelDiagramParts To the Distributor WarrantyTo the Dealer Name of Owner Address Installation Data Sheet