Initial Installation
QUALIFIED INSTALLERS ONLY
19.Place a bead of high temperature silicone on the flue pipe and slide the flex liner over the collar, secure the flex liner with three (3) sheet metal screws evenly spaced.
20.Align all straight sections of pipe, slipping all joints together and installing with three (3) sheet metal screws evenly spaced.
21.Install the brass decorative rings around each joint making sure this decorative ring covers the sheet metal screws that secure each section of pipe together and secure to vent pipe in the slotted tab on the backside of the pipe so that the fastener would not be seen.
22.Secure the horizontal section of pipe to the inside finished collar by installing a screw in the tab on the inside finished collar. This will prevent the pipe from being disconnected at the vent terminal.
23.Light the appliance and ensure proper operation.
Wall thimble | Horizontal wall |
fire stop | |
| termination |
| Wall framing |
Inside finished collar |
|
Decorative |
|
brass rings |
|
Exhaust 4" |
|
flex pipe |
|
Combustion air |
|
6 5/8" outer pipe |
|
Flue pipe adaptor |
|
Figure 23: Assembly of Venting Kit.
17