Enviro EF4 owner manual Outside Vertical Installation

Page 21

Installation

 

Rain cap

 

Flashing

 

24"

 

(61 cm)

 

3" (7.5 cm)

 

Clearance

 

2"

 

(5 cm)

 

Support

 

bracket

 

Tee with

 

cleanout

6"

Type "L"

(15 cm)

vent

 

Fresh air

 

intake

Non-combustible

Existing floor

floor protection.

(combustible)

Figure 24: Outside Vertical Installation.

HEARTH MOUNT INSTALLATION - FREESTANDING:

��������� ���

��������� ������

������ ���� ����

�������� �� �����

������� ������ ������

��������� ��� ��

������������ ����

����������� ��

������� ��� �����

������ �������

�� �������� ����

��� ����� ��� ������

������� �� ��� ���

���� ��� �� �����

 

��� ��

 

���� ���

 

����� ����������

������� ���������

����������� �����

Refer to Figures 25 and 26.

1.Install the hearth pad.

2.Lock fireplace damper in the open position.

3.Install a positive flue connector at the fireplace dampers.

4.Connect a tee or a 90° elbow to the exhaust pipe.

5.Install flexible stainless steel liner or listed pellet vent to the top of the chimney.

Figure 25: Freestanding hearth mount installation.

21

Image 21
Contents EF4 Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Reasons WHY the Unit Overheated Operating InstructionsSpecial Notes Stove. When cool enough, the stove will shut down Tools Required to Clean Unit Routine Cleaning and MaintenanceBurn POT and Liner Exhaust Passages 2-3 daysFreestanding ASH PAN Insert ASH RemovalPost Season CLEAN-UP Installation of firebox backingCleaning Plated Surfaces Exhaust Vent seasonScrews to take out to remove stove from pallet InstallationDimensions of EF4 Freestanding Minimum solid fuel burning fireplace opening Height 211⁄8 Freestanding Pedestal Vent surfaces can Exhaust Fresh Air Intake Unit on it Locate the center of the exhaust Is the recommended installation set up Inside Vertical Installation Outside Vertical Installation Freestanding hearth mount installation overview Masonry fireplace installation Surround Panel, back view RemovalInstall Plated Door a Cleaning the Plated Door aRemove Painted Door a Stove will not operate when hot √ Check the hopper for fuel TroubleshootingDo not What to do ifConvection blower will not function normally Exhaust motor will not function normallyTroubleshooting Potentiometer Readings Dial-a-fire has no effect on the fireStove will not shut down Stove keeps going outWiring Diagram Reference Number Description Part Number Part ListLog set Part List -Options DiagramComponentsPart Part Diagram Steel Warranty To the DistributorFor the do-it-yourself Individual Name of Owner Address Installation Data Sheet