Enviro EF4 owner manual Warranty, To the Distributor, For the do-it-yourself Individual

Page 36

Warranty

Sherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electrical components. The above limited warranties are extended only to the original purchaser.

There is no warranty on the following parts:

Glass window

Fiberglass rope gaskets

refractory material

burn pot liner

paint

enamel finish or gold plating where it applies

**NOTE: The paint on the brick firebox lining may peel. This is due to the extreme conditions applied to the paint and is in no way covered under warranty.

WHEN FILING A WARRANTY CLAIM PLEASE COMPLETE THE FOLLOWING INFORMATION ON AN OFFICIAL WARRANTY CLAIM FORM:

TO THE DEALER:

-Name and address of dealer,

-Date of purchase

-Name, address and telephone number of purchaser

-Name, address and telephone number of installer

-Date of installation, and

-Serial number of the appliance

Ensure that you specify the nature of the complaint, defect, periodical malfunction, etc.

TO THE DISTRIBUTOR:

-Sign and verify that work and information are correct.

-Description and part # of any parts replaced.

The limited warranty covers defects in materials and workmanship as long as the products has been installed according to the manual’s instruction. If the product is damaged or broken as a result of mishandling or misuse, the warranty does not apply. Removal and re-installation costs are not covered under this warranty.

It is the manufacturer’s option whether to repair or replace the appliance. The shipping cost to and from the factory is to be paid by the consumer. All warranties by the manufacturer are set forth herein and no claim shall be made against the manufacturer on any oral warranty or representation.

The manufacturer assumes no responsibility for damage caused by household power fluctuations or power surges.

Under Warranty

For the do-it-yourself Individual

The consumer should be aware that the pellet appliance needs setting using tools that he/she might not have. It is recommended that you have a qualified installer install your pellet appliance

Sherwood Industries Ltd. reserves the right to make changes without any notice.

36

Image 36
Contents EF4 Table of Contents Introduction Store pellets at least 36 1 m away from the pellet stoveUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Reasons WHY the Unit Overheated Operating InstructionsSpecial Notes Stove. When cool enough, the stove will shut down Routine Cleaning and Maintenance Tools Required to Clean UnitBurn POT and Liner Exhaust Passages 2-3 daysInsert ASH Removal Freestanding ASH PANInstallation of firebox backing Post Season CLEAN-UPCleaning Plated Surfaces Exhaust Vent seasonInstallation Screws to take out to remove stove from palletDimensions of EF4 Freestanding Minimum solid fuel burning fireplace opening Height 211⁄8 Freestanding Pedestal Vent surfaces can Exhaust Fresh Air Intake Unit on it Locate the center of the exhaust Is the recommended installation set up Inside Vertical Installation Outside Vertical Installation Freestanding hearth mount installation overview Masonry fireplace installation Removal Surround Panel, back viewInstall Plated Door a Cleaning the Plated Door aRemove Painted Door a Troubleshooting Stove will not operate when hot √ Check the hopper for fuelDo not What to do ifExhaust motor will not function normally Convection blower will not function normallyTroubleshooting Dial-a-fire has no effect on the fire Potentiometer ReadingsStove will not shut down Stove keeps going outWiring Diagram Part List Reference Number Description Part NumberLog set Part List -Options DiagramComponentsPart Part Diagram Steel Warranty To the DistributorFor the do-it-yourself Individual Installation Data Sheet Name of Owner Address