Enviro EF4 owner manual Freestanding hearth mount installation overview

Page 22

Installation

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

Figure 26: Freestanding hearth mount installation overview.

MASONRY FIREPLACE INSTALLATION - FIREPLACE INSERT:

The fireplace insert model requires a surround panel and a pedestal. When installing this unit, ensure that the pedestal is removed from the inside of the hopper and installed on the bottom of the unit (see

“PEDESTAL INSTALLATION - FIREPLACE INSERT”).

Assemble surround panel (see “ASSEMBLING THE SURROUND PANEL - FIREPLACE INSERT”) before starting installation.

A non-combustible hearth pad must cover combustible flooring underneath, as well as 6” (150 mm) in front of the heater and 6” (150 mm) to the side of the heater.

1.Install the hearth pad.

2.Lock the fireplace damper in the open position.

3.Install a positive flue connector at the fireplace damper.

22

Image 22

Contents EF4 Table of Contents Introduction Store pellets at least 36 1 m away from the pellet stoveUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Operating Instructions Reasons WHY the Unit OverheatedSpecial Notes Stove. When cool enough, the stove will shut down Burn POT and Liner Routine Cleaning and MaintenanceTools Required to Clean Unit Exhaust Passages 2-3 daysInsert ASH Removal Freestanding ASH PANCleaning Plated Surfaces Installation of firebox backingPost Season CLEAN-UP Exhaust Vent seasonInstallation Screws to take out to remove stove from palletDimensions of EF4 Freestanding Minimum solid fuel burning fireplace opening Height 211⁄8 Freestanding Pedestal Vent surfaces can Exhaust Fresh Air Intake Unit on it Locate the center of the exhaust Is the recommended installation set up Inside Vertical Installation Outside Vertical Installation Freestanding hearth mount installation overview Masonry fireplace installation Removal Surround Panel, back viewCleaning the Plated Door a Install Plated Door aRemove Painted Door a Do not TroubleshootingStove will not operate when hot √ Check the hopper for fuel What to do ifExhaust motor will not function normally Convection blower will not function normallyTroubleshooting Stove will not shut down Dial-a-fire has no effect on the firePotentiometer Readings Stove keeps going outWiring Diagram Part List Reference Number Description Part NumberLog set Part List -Options DiagramComponentsPart Part Diagram Steel To the Distributor WarrantyFor the do-it-yourself Individual Installation Data Sheet Name of Owner Address